Dorman924-284 Front Differential Vent Breather Compatible with Select Lexus / Toyota Models

Worked like advertised

I built a set of new axle housings for my Jeep. Somewhere in the chaos I lost my originalDiff breathers. Ordered these, they fit my vent lines perfect and were exactly what I needed

Relocated my diff breather up on the gas filler tube out of the water and road grime.

Perfect for for my 4th gen 4runner v8 for the front axle. This is not down low on the axle like the rear. A factory tube runs it up above the top of the motor on the driver side. Really no need for hoses or clamps like on the rear.

Used at end of fuel line as breather vent on my hot rod fuel cell

My F150 Lariat didn't come with a breather, open ended vent could let in elements or water if accidentally sprayed down the vent tube.Tight fit-just connect to open end vent hose.

Ok

I used this breather valve to relocate the existing rear breather valve on my 2001 Tacoma Trd. It was originally mounted directly on top of the rear differential making it susceptible to water so I used this in combination with some 1/4” silicone vacuum hosing to reroute the breather to up behind the driver’s side tail light. Worked perfectly and now I can drive through deeper water without worrying about my rear differential sucking in water.

Used this on a 2005 Toyota RAV4 for the vent mod off the rear differential. Works perfectly with 5/16 fuel line

used to replace old unit on "scuba mod" for FJ Cruiser

Fit perfectly into my axel vent tube hose, the original came off when the hose was dragging on the road without me knowing.

This works fairly well for a rear differential breather mod for a 2nd gen Tacoma. I used 1/4" fuel line which was very tight to get on the barbed fitting. I had to heat the fuel line under hot water a few times as well as use soap to lube the fitting up. once on it is not going anywhere. I added a hose clamp to ensure it does not move.

Ideal for diff and transmission breather on my Toyota 4x4