KCH10 Magnetic and Hanger Strap Use for Multimeter Meter Hanging Hang Kit

Product works great. The magnet is much stronger than I was expecting. Worked perfectly on my Fluke 902FC meter. Only complaint is strap is a little long.

Great product and service 👌.

This magnet is perfect. I have the 116 HVAC multimeter and it fits great and the magnet strength is super strong you are not going to have to worry about it falling or slipping on surfaces. The only thing I'd say is I wish the strap was a little shorter it sits about 6" away from the meter fully extended, but that's just a preference. There's no need in my head to spend thr extra money on the name brand this will do the job just fine.

It works well with the fluke 902fc hvac meter. Strong enough to keep the meter where you want it on the furnace ac or duct work.

This works, but it is not quite the same as the original strap that comes with the meter I have. It is also cheaper than the name brand, and it does what is required. The magnet seems to be comparable to the original and supports the meter for any normal application. Note that some meters have the slot on the back of the case and other, very similar meters do not, so you might want to check your meter and set your expectations accordingly.

Magnet is strong, it holds a chunky Habotest/Kaiweets HT208D on a 3/8 " dia. screwdriver- even better on actual flat surfaces! Magnet is in a flexible rubber holder. Caution- width of strap is 0.98" (in description and as measured). This was too wide for my meter slot, so I used a 0.79" strap that I had. The orginal strap could also have been cut thiner. $11 seems like a lot, but the product quality is inline with the value of meters that depend on it.

This is a good magnetic strap and is a very useful accessory for a multimeter. I bought this to use with my Extech 355 full sized multimeter weighing 0.82 lbs. The strap holds this meter very securely - no sliding of the meter down the wall. Users should remember that magnets work best on plain steel and iron. Stainless steel is much less magnetic (depending on specific alloy) and may not hold as well on those surfaces. I am pleased with this purchase and would buy it again, if needed for another multimeter.

Received Dec 12th, 2019. $13.23 after tax.Seems to hold good. on a breaker box, doesn't seem to move with my Fluke 87v attached.If I hold my 87v at the same height as the magnet and drop it...the magnet moves 2 inches. But then doesn't appear to creep down any more after that. I think this will be plenty of strength for my application, and don't know if the official one is much stronger?when my 87v is attached to the side of a refrigerator, it slid a few mm, then appeared to not move after that. Fridge side was much slicker than breaker box.when comparing to the official magnet, it lacks the quick snap in clip...but i am going to keep it attached, even when i put it in my case. If you have many meters, that you want to swap clips, this could be a downside...but not for me and my application.I'll update if the quality of the strap diminishes.***Update Dec/19/19. Manufacturer of the official fluke clip said theirs would move a little too in the same test I did. So the strength of the magnet seems comparable.***FYI the official one can wrap around a non-magnetic pole, and attach to itself.... If you can't find something magnetic to attach it to. This is another advantage of the official one. But for less than 1/3 of the price, and I don't foresee this being an issue in my situation.... It shouldn't be a problem for me.