Sniper A1 & A2 Front Sight Post Steel Adjustment Tools with 4/5 Prongs, Black

Works well

4 pin does not work on Magpul BUS sights (teeth on tool too big) nor did this for A2 front post sight, same issue, teeth too big.

As described

Fits bit its a little rough. You have really dig it in and damages/scratches sight. Overall it does the job.

Fits both an A1 and A2 sight post, however, some of the teeth did have some surface rust and were slightly bent. A little scrubbing with some CLP and a bit of tweaking with a pair of needle nosed pliers, and it was all good. Would be 5 stars if they were packed and shipped in such a way as to prevent rust and bending in transit/storage.

Just like the issue item

Works great. Wear gloves if you don’t want to shred your hands.

As you can see in the attached photos, this does not fit either type of front sight post. The diameter is slightly to small, the pin spacing on both ends is too narrow so that only one pin can ever fit, and even that single pin is too short to depress the lock plunger far enough to allow the post to be rotated for adjustment. I have both style posts so wanted once combined tool instead of two seperate tools. In the attached photos the 4 pin A2 is on the left and the 5 pin A1 is on the right. In the first photo, yu can see the A2 post does not fit in the new combo tool (tall & narrow) while the A1 post fits in the old dedicated tool (short & wide). The second photo shows the same A2 post fits the old single purpose tool (short & narrow) while the same A1 post does not fit the new combo tool (tall & narrow). The final photo shows how the pin length on the combo tool is only about half the length of the pins on the two dedicated tools. I will be requesting a return on this item.