Chiller for Ice Bath and Cold Plunges Including All Hoses and Pumps. 1/3 HP, 2/3 HP, 1 HP Models

The 1/3hp unit was unable to get 120 gal cold plunge under 60 degrees in 63 degree weather in Ohio. Would advise a bigger unit of at least 2/3hp for 120 gal cold plunge. Update-- I purchased the 1hp for my 120 gal cold plunge and that did the trick. The chiller works great and has no problem achieving and holding 50 degrees even in 90 degree weather.

Pump stopped working

This thing works like a charm! I was so disappointed when my Edge Theory chiller stopped working. This chiller is the perfect replacement and super easy to install.

I bought a cold plunge from Costco and bought this to keep the water cold. At first it looked like the pump didn’t work but it was because it needed to be filled with water first. I used my hose to fill the pump line with water and then placed it in the ice bath. It works perfectly now. The only reason I gave it 4 and not 5 stars is because the temperature gauge is always about 5-6 degree off. If it says it’s 46 degrees F then it’s actually 40 degrees.

Broke in less than a year. Took about 24 hours to reach desired temp of 55 degrees

Stoked on this setup. Bought it for a 128 gallon inflatable tub and it holds my preferred 42 degree temperature in direct western sun, so far up to 75 degree days (that's the hottest it's been since I bought it). I was nervous about it being powerful enough over the hot summer months but it seems like it will be. You can barely hear it running, no issues noisewise. Also, having all the accessories (pump, filter, tubes, connectors, is a huge perk. Took maybe 20 minutes to figure out the setup. Very happy.

Did not work for more than 2 minutes. After restarting it and calling and working with customer service 3 times it would never work for more than 2 minutes.

Pump already went out so looking to have to buy a new one. They don’t list any of the parts on here so that’s why 3 stars

Exactly as I'd hoped - cools 400 l cold tub perfect.

Keeps the tub cold

Works like it should keep my cold plunge at the temp I want

Connections on top of chiller are all cheap plastic, they give you a o ring to seal the connection but it still has a minor leak, you can only tighten so much before you risk cracking the cheap plastic. Had to use silicon to seal around and stop the leak. They give you brass connections to screw into the ice bath, u'd assume they would of made connections on the chiller brass as well. Maybe choose one with better connections.