Clarke CWTS1 Work Table Supports (Pair)

Once worktop was on top to support the both frames ,it was solid , I even clamped a bench vice on to the worktop, it handles the weight perfectly, it can handle a good bit of weight ,so worth buying. As long as you have support on the under section .

Very strong and good value. Only minor point is no pre drilled hole further down the legs to attach a cross brace which is necessary to make it rock solid. Need a strong drill bit to get through. Just used some cheap framing timber glued together for the top and a few more for a handy lower shelf.

Got these to make a bench in the garage, been a year now and have used and abused and they are holding up well… If I needed more, I’d for sure buy again.

Very easy to set up my new work bench. Well made sturdy British engineering.

Very lightweight construction

Very sturdy work bench legs. I’ve sprayed them silver added a back board and shelf to triangulate Also castors with brakes It’s the prefect set up now.

Needed to drill holes in the uprights so I could add a brace …..other than that they’re absolutely fine

Delighted with how this worked out. Bolted an old counter top I had to the legs, with timber along the bottom and a brace at the back as described in previous review. It's worked out very well.

Ok, wer wirklich stabile Füsse für einen schweren Werkbank braucht, sollte die Profi Variante kaufen, allerdings kostet da ein Bein soviel wie hier zwei. Ich wollte das nicht ausgeben und habe drum diese gekauft. Mit einer diagonalen Versteifung aus zwei Holzbrettchen hält das jetzt auch meine 2.5Meter, 4cm starke Buchenplatte.