I/O Shield Plate Blank Backplate PVC with Adhesive, IO Shield Plate Blank Universal DIY for All PC Motherboards Desktop Computer Case, Cutting Any (172 * 58mm, 2Pcs, Black)

Very good 👍

Don't waste you money, this flimsy and very thin plastic. A waste of time, almost imposible to cut out a decent shape to fit. It is held in place with sticky foam straps so easy to dislodged, not a snap in place like the original. Leave alone.

Unless you own a stencil do not purchase, if you do you may as well just get the correct Io shield. A little too expensive for what it is.

Yet to fit this properly, but it looks like it will be adequate even if a bit of a faf to fit. The plastic is pretty thin and flimsy - not at all rigid, so will rely on the adhesive to survive the rigors of daily life. If you are going to do a lot of input swapping you might need a more robust solution. But the templates are helpful, and the pack arrived very quickly and well enough packaged. A qualified recommendation, but it is a recommendation.

Poor its just a dust cover like on top of your computer no matter how careful you are it dont look great and if you plug anything in be very careful as the slightest push will make it come off

If you've every bought a used motherboard without an IO shield this is a great way to make one yourself and not have a hole in the back of your case. It's a 2 pack, but you're likely to mess up your first attempt, so if you need two, buy another pack. I used a craft knife and was easily able to cut out some relatively crude holes. Not as pretty as the original shield, but better than nothing. It does leave a relatively sharp edge, so be a bit careful. Template also doesn't have firewire, which albeit niche, would have been nice to have for making I/O shields for older boards.

I used this to cover and protect the back connection plate on my p.c. to stop dust and debris from entering the unit . It is a bit fiddly to cut but as long as you take care a reasonable job can be achieved. I’m happy with it although it is quiet expensive for a piece of uncut mesh .

If you dont have an I/O Shield on you motherboard, this will work as a replacement. I even managed to mount wifi antennas to it. It was easy to cut with a razor blade and small scissors.

You have to be patient but results can be really good.

Da ich einen weißen pc habe ist es perfekt. Es lässt sich super mit einer Schere bearbeiten und haftet sehr gut. Auch die mitgeführten Schablonen sind top.

Utilisation et mise en œuvre très difficile les formes à découper ne correspondent pas de plus l'autocollant transparent sur la grille noir ne se voit pas c'est compliqué à utilisé

Não é fácil de se utilizar