URO Parts 67127302589 Windshield Washer Pump

Fits 2008 BMW 3-series (335 in my case) windshield washer reservoir. No leaks after 1 year.

I knew I had a problem with my washer on my 2007 BMW convertible, but I did not know if it was a bad pump or just a leaking grommet. So I ordered both before I started to job to be prepared for whatever I found. I followed a you tube video from CarkingSpot that was very helpful. The replacement from start to finish took about two hours. i used both the new pump and grommet/strainer just to be sure, and tested the washer before I put everything back together. The new pump works great, and shoots the washer fluid just as well as the old factory pump did. I think this is a great, cost effective alternative to some of the more expensive pumps out there.

Bought two. One for the front windshield and one for the rear window. Front worked perfectly. Rear had to be modified due to the different style electric harness. Very easy to do. Just shave down a strip of plastic on the harness. Will work for both glass placements. As cheap as these are, plan to replace both as the reservoir is not easy to access.

Since the original part was not working when I purchsed my vehicle (2015 BMW 328i), I don't know how the original pump behaved, but this replacement seems to do the job very well. I wouldn't call the replacement simple, but it wasn't terrible. Probably took about an hour of time to install. On this vehicle, it requires removing the front passenger side wheel-well liner and the washer fluid reservoir. I had to refer to a couple of videos for some hints, but one of my main sticking points when removing the liner was when I needed to remove the attached plastic trim piece on the outside that is held with rivet-like plastic bits. They appeared at first to be possibly small hex-head screws since they had small dimples in the middle. But the center is actually a small plastic pin/rod that you need to push through with a pick or some other pointed tool. Once that has been done, then the rivets, which are split and expand with the pin, will have collapsed allowing the trim and the rivets to be removed. The other point of trouble was with the fill neck. The hose has to be removed from the reservoir to allow it to tilt forward enough to free the bottom of it from the keyed opening it rests in. Keep in mind that the hose is thin plastic flex tubing...not rubber (which I thought). I ended up piercing it with a pick while trying to remove the hose from the capped fill opening. You can get a little additional wiggle room by removing the screw-expanded rivet that holds that fill opening. In the end I managed to free the hose from the reservoir, but I'm not sure how it was actually freed as it's got barbs which snap it in place. Once you manage to get the reservoir out, the rest of the steps are pretty straightforward. Included photos comparing the original part and this one.

It works great on my 2008 BMW 550i, weaker than OEM but does it job.

Very easy to install. Fit perfect. I have a BMW 428i series year 2015. No leakage. Quality great for a great price.

Exactly as described worked perfectly

Arrived fast and fit perfectly. 2011 BMW 335D

Funciono muy bien

取り付けは一苦労する場所ですが、純正より強く出るんじゃという勢いでした。

Cheap and good

Fit my 2007 BMW 323i e90 perfectly. It was installed fall 2023 and working without any issues.

installer depuis plusieurs mois et fonctionne comme un charme