Meprolight1001938-SSI CZ 75/85/ SP01 G/G Fixed Set TD - multi, N/A

Great addition to my CZ Omega. Factory sights are a bit too hard to see with these old eyes so I thought I'd try the Meprolight Tritium night sights and that was it, just what I needed. Amazon.ca shipped in a week ,and a great deal too. I had them installed with in a 1/2 hour of receiving them and took my Omega to the indoor range to try them out. What a difference these sights made for me. My first 10 rounds at 20 meters scored 2 in the black and all other rounds were close to the left side outer ring of the black. With a little adjusting with a brass punch and hammer ,The next ten rounds scored 5 in the black and it just kept getting better from there. I had a match at the outdoor range the following week and the sights work as well in the day light ,with the white dot front sight as bright as can be . I installed these sights my self in my work shop but really they need the care and attention of a gun smith.

I purchased two sets of these, one for my 1996 and one for my 2013 FULL SIZE CZ-75 B's, and they fit perfectly.the new front sight DOES NOT have the small notch machined into the bottom for the roll pin. BUT, you can either use a small file to install the notch or you can find a smaller pin. I used a small jewelers file and installed my front sight with no problems.the rear sight fits just as perfectly. BUT, remember the rear sight MUST be driven out from LEFT to RIGHT with the orientation of looking through the sights like you are going to shoot. AND the new sight MUST be driven in from the RIGHT to the LEFT.once both sights are installed you can use a laser bore sighter and "tap" the rear sight into the proper position for a "Dead On" aim point.NOW, with that said, these sights are great, they are nice and bright green and should last for years if not decades.

Very nice sights. Huge improvement over stock. I probably won't ever shoot at night or low light, but daytime target acquisition is much improved.

These little sights are very bright and well made. It was a little tricky to get them installed, on my CZ 85, because you have to knock out the pin holding the front sight on; but after that, it was easy. You will need to disassemble the pistol, so you only have only the slide to work with. Wrap the slide with cloth, and put in a vice. Now you can punch out the pin holding the front sight on more easily.I'm actually amazed at how bright these sights really are. It will be interesting to see if they stay that way for the entire twelve years this product is suppose to last for. I'm completely satisfied with this product, and I'm sure I'll be even happier with it if I ever find myself in the situation of needing a gun in a dark environment. Guns aren't much good if you can't see to shoot them.

These regulate very well with a compact CZ75. For all practical purposes, POA=POI pretty much from 5 yards out to 60.Tritium is bright, picture is sharp. In bright daylight, however, these are little more than a plain Jane 3-dot setup. You get what you pay for, there's not much extra shine around the front dot.The rear is a bit wider than the top of the slide. Nothing obnoxious, barely noticeable, but not as sleek as the OEM irons. But - it does make it easier to push it without scratching the coating, so maybe it's a good thing.Installation-wise, it's very tight, but if you're brave and careful it installs without filing. The front blade needs to be drilled for the pin, and it does not drill easily. The blade originally blocks only the top half of the pin channel, so thin drill bits tend to break on contact. But that's how CZ designed it.