Podoy 371LM Remote for Liftmaster Garage Door Control Opener 315MHZ Replacement

I returned this product, as I could not get it to pair with my garage door opener. I returned it to Amazon (thank you) and purchased a Liftmaster mini-remote. The (edited) instructions from the successful remote, follow:1) Start with your garage door closed.2) Press and hold bottom button on the remote control until the blue LED stays solid (approximately 15 seconds) then release the button.3) Press and release the Program/LEARN button on your garage door opener.4) On the remote control, press and release the button that you would like to program twice. The blue LED will blink and the remote control will begin sending the pre-programmed codes to the garage door opener. Transmission can take up to 60 seconds.5) When the garage door opener, immediately press and release either of the buttons on the remote control to confirm the code and exit programming.Hope this helps. No programming instructions to speak of with the Podoy, but I would have loved to have tried these instructions. It was a nice remote.

I have a LiftMaster Elite 3850 w/ Security+This remote unit is much higher quality than I expected when I placed the order. The guard that prevents accidental button presses slides smoothly and has a quality feel to it. Programming the remote took about ten seconds. You just press the learn button (purple on the models this remote supports), press the button on the remote you want to open the door, then the lights on the garage door start to flash and your done.I was hoping I could program one of the four buttons to work only the light on my unit but it seems the LiftMaster 3850 doesn't support that. Bummer, but not the fault of the remote. I guess if you had multiple doors to open you could assign those to the other buttons.

I have the Sears Craftsmen purple learn button garage door opener. Its so simply and easy to program. Have your garage door down/closed before you start to program. Then all you do is press the purple learn button on your garage door motor for a second and the little light by the purple learn button will light up. Then you press any of the 4 buttons you want to use to control your garage door. The main light bulb will flash a couple of time and that its. Its programmed. To test it, just press the button you programmed and your door should open. Your can not erase the program from the remote. If you dont want your programmed remote anymore, you will need to reset your purple learn button motor by holding down the purple button for about 6 seconds until the little light goes off. Now the motor has reset. All your previous remotes will not work and you will need to reprogram each one of your remotes as how I have stated above. If you lost your remote, this is the same steps you take.

Didn't work. I have a Chamberlain HD420EVP , yes it has the Yellow learn button as well. There are NO instructions included but it isn't complex, that wasn't the problem. I tried everywhich way to program either one of my garage doors. I even tried cloning my 953ESTD. No bueno, neither worked. I erased codes in between attempts as well. I have another one of these generic 4 button FOBs and i used it to test this unit. This unit DOES work with a smart LED setup i have, but that's not the same as a Chamberlain Door opener lol. Unfortunately my quest continues. I may just order the OEM. I'm looking for a small fob for my R1 though. Hate getting off to enter my door code on the panels.

OK we have a warehouse rollup door. I found this by searching the numbers on the visor transmitter and this was a match. NOTE it says you must have a purple button on the receiver. NOT true our box has a WHITE radio button. I pushed and the new transmitter was programed that easy. Just took a 20' ladder to get to the white button inside the controllerThe quality of this transmitter is high, well constructed metal and plastic. A++Bought a second one for a co worker after reviving the first one.

I LOVE having this garage remote because I can't see my garage door to know if it's open or not.....now I don't have to go back up to the house each time it's closed!! This remote works better than any other remote I have for our garage doors and it takes about 10 seconds to program. Super easy!!!

It's a handy device...the one that worked. The other would not sync with the openers. "Customer Service" by Podoy is, well, bad. The product ships from China (several weeks for delivery). Podoy's solution to a non-functional opener: return it to China. Really? For a $13 item?

Bought it to use for my motorcycle. Perfect size and the cover for the buttons prevent me from accidentally pressing any buttons when my keys are in my pocket. It was extremely easy to setup and cost half the price of the original Liftmaster key chain garage door remote.