Question 1

Is it convenient to change the mold?

Accepted Answer

Yes,there is a video of changing the mold for your reference

Question 2

How do you  put machine together

Accepted Answer

see the video.
Use a little more pressure on the second press, preferably twice. If the molds do not join together on the second press, the button will not seal

Question 3

Q: These are 2 of the bad ones that didn't attach to the back when I pressed. How to avoid it?

Accepted Answer

Answer:

1: Make sure there are no problems with the installation. If something goes wrong with the installation, all subsequent steps will fail.

2: One of the most common causes is that your paper is too thick or too thin.We recommend using 24-28 pound copier paper.

3: wrong circle graphics.Your graphic has to be cut exact and even. It should not be bigger than the mylar and the edges need to be nice and even.

4: You need to push the handle down with a bit of force in the last press. It is best to hold the handle tightly with your hands when pressing for the last time, so that the upper and lower molds can be tightly combined with each other.

5: The top die may become loose after a long time of use. If the mold is loose, that's maybe the cause you failed pressing. Because the vertical force between the upper and lower molds cannot be applied when pressing. Tighten with an L wrench before installing the upper mold if it needs(Do not over tighten, make sure the upper die can rotate properly)

6. Don't forget to put the metal pin that holds the sliding mold fixing. If there is no metal pin, the force of the upper and lower molds will not be uniform, which will cause the button unsealed. Metal pins are easy to lose, so we've included a few extra for emergencies

7. Only put one piece of paper and mylar at a time, too thick material can cause jamming and seal failure. Since papers or mylars are easy to stick together, you may not notice how many layers are there when putting

Question 4

why the left side isn't crimping and lifting up the paper, front metal piece and mylar?

Accepted Answer

When crimping the left side, the pegs of the top die should not go into the holes. but when crimping the right side pieces, the pegs on the top die need to go into the holes

Mryitcal Button Maker Machine Multiple Sizes, 1''+1.25''+2.25'' Pin Maker Button Press Machine W/300 Sets Metal Pinback Button Parts, Badge Button Machine for DIY Photo badge, Team Badge, Party Favors

Details

Description

Have a Question? See What Others Asked

Common Questions

About Us

Customer Services

Customer Support

Regional Access

Legal & Policies

Social

Get the App