Filling Loop Part L Compliant 15mm with End Caps

Tap levers are short and clean, on/off is tight and positive, loop is long (enough to go around minor obstructions), the loop ends are an odd size being neither 15mm or 1/2 inch, but it's easy to fit. The instructions just confirm common sense. The only difficulty was removing the old loop. Each compression joint was onto a short 15mm stub so the old nuts were not free to slide back along the pipe to expose the olives. Had to cut each old nut off to expose the olives then carefully split the olives to get them off. With all the old fittings removed from the stubs fitting the new loop was a breeze.

Well made filling loop with good metal valve levers. Easy to install and much better than the loop that it replaced as it had started to pass water thus over pressuring the boiler. Very pleased with this filling loop.

I was have a leak from my refilling loop on my combi boiler which was caused by a leak in the valves, after replacing the refill loop, this stopped, after a week there is no longer a leakPlumbers wanted too much for something that was fixed in about an hour, including turning on and off water a couple of times, as the valves need to be tight to prevent leakage.

The part itself was fine but it didn't fit my boiler so it was returned and I was refunded.

Fixed the minor leak issue on my boiler, thumbs up

Good quality with metal valve handles. Not 1/2 " thread on braided flex.

Excellent bit of kit. With the double isolation valves so much better than the one I had before

Managed to cross thread the nut. Could not feel any resistance. Completely chewed up the soft alloy. Ruined my evening and have to wait for another to arrive. Not quality!