24VDC Highest Density 5-in-1 5050 RGBWW (RGB+Warm White+Daylight) 112LEDs/m Bright RGBCCT LED Strip 16.4FT Dimmable Tape Lights for Bedroom Decor (16.4Ft IP20 Non-Waterproof)

These are bright! very rich colors. Only con is if you cut them and solder new leads, it is a challenge with 6 tabs so close together.

Bright enough to replace the hue strip while remaining inexpensive, open control, and custom installs

This is a very professional product. Decent quality. You need to cut and rgbcw controller to make it work.

Used to provide color coded operational lighting and white light for better video on my 3D Printer (used along with other device for lighting control). Works very well lights are more than bright enough and several months old and have had no failures.

Diodes started dying 2 days after installation. What is really odd is there are dead WW diodes when the CW diodes work at the very end of the strip wher it was cut on the solder pad. I also have dead CW & WW diodes in a corner where as the RGB diodes work perfectly in the same place.I really wanted to love these as the density of the diodes is EXACTLY what I was looking for.

The lights are bright, the colors are accurate, the adhesive sticks great in the channels I purchased, and they were easy to install with the led controller I got.But I’m concerned about the durability as the strip part itself is very ridged and I was unable to get the leds to lay completely flat without being worried about them breaking. Every few sections there is a crease that is impossible to get out without feeling like you’re going damage the lights. Another issue is that if you cut the section too close to the led portion you intend to use, that last group of leds will not work anymore and you’ll have to cut them off and be left short.

These were easy to work with and very bright. The onpyniasueni have is that they have a refresh frequency that's causing some odd lines on my 3d printer camera.

Very bright and much more control over rgb and white settings.