LINKITOMWhite Oval Aluminum Housing Ultra Slim Reverse Trailer Tail Light Kit, 24-LED Back Up Tail Lights for Boat Trailer Truck RV [Surface Mount] [DOT Certified] [IP67]

Solid construction. Easy to wire and install on the trailer. Nice and bright. Should do the trick.

The media could not be loaded. FINALLY found the solution for a bright brake light on my Honda F6B! The 2013 - 2017 Goldwing F6Bs are great motorcycles. My only complaint is the rear factory lighting left something to be desired. Even after several modifications, I was still not impressed with the rear brake light - UNTIL I ran across this awesome light. I installed it in place of the unlighted reflector just above the license plate and hooked up just the bright circuit (red wire) to my brake wires. This light is VERY bright. Perfect for a brake light. DOT approved, waterproof, sturdy aluminum construction. Perfect solution. 6 stars!

I built a power wheelchair carrier for the back of my truck, and put these lights on the back of it. I plug them in to my trailer light connection and get Tail Lights, Turn Lights, and Stop Lights, all on one connection. They are very bright and easy to see. As a double amputee I wanted the extra safety of lights behind my power wheel chair when I take it with me to travel, go shopping, or to the doctor's office, and these lights are perfect for this.. They are thin and low profile, L.E.D. which is a low power draw, and very easy to see even in bright sun light.. They are completely sealed to be water proof, so I don't worry about rain damage.. They were well worth the cost, which wasn't much compared to others I looked at..

The Linkitom ultra-slim LED tailights were accurately advertised. When I needed new lights for my trailer these seemed to be the exact answer to my needs. However, now that I've used them I have mixed emotions with these lights. First the Pros: They are cute little lights. Very affordable. The size was perfect. They do fit the recessed light fixture cavity built into my trailer frame. The instructions were accurate and easy to follow. The Cons : the mounting bolts provided with the light set are so tiny my first thought was that there was a mistake in the packaging until I inspected the light housing. The holes used for mounting are so small and so close to the plastic lens that if you wanted to use any bolt larger than what is provided the bolt head would hit the plastic lens and damage the lens when tightened. I had actually thought about drilling the mounting holes larger but that wouldn't have really solved the problem. I ended up using the supplied bolts. The mounting holes should be spaced wider in the housing so a more substantial bolt could be used. Second, in my opinion, the wires built into the light are much too light gauge when compared to the average trailer light wire. I think the wires are going to become a problem. Finally the actual light brightness is unreal. The light intensity used for the taillight function is almost as bright as the lights used for turn and brake function. There should be a much greater and a more distinct difference between the two intensity levels with the tail light function being toned down a bit. Overall, I am using the lights and they are working. My continued use will depend on the lights reliability. If or when they fail they will be removed and not used again. I would need to see an appreciable improvement in the mounting and wiring areas for me to reorder or to give a recommendation to others. Sincerely, Charles.

I like that they are thin and very bright. I will be buying more

I installed these lights on my boat trailer and after three trips to the lake, half of the LED’s quit working.

I got these for a small trailer project and they are just right. Very bright...much more so that I was expecting and work great using a 4 pin flat plug. Fast shipping as they got here 1 day earlier than expected.

easy to install, only a couple of small wired coming out the back, running and brake lights are very bright, I tried a couple of other China lights first but they were dim, came apart and wires broke

great

Reversing lights on a C1 Corvette.

Il me reste à savoir si elles seront étanches à long terme , l’avenir vas me le dire…