*POWER SUPPLY IS NOT INCLUDED* If you have 220v-264v power, then Bitmain recommends using the APW3++ power supply. If you have 110v-120v power (standard power outlets in the US), then the following power supplies have been confirmed to work well: EVGA's SuperNova 1600G2 AntMiner S9 Specifications:1. Hash Rate: 13.5 TH/s ±5%2. Power Consumption: 1323W ±10% (at the wall, with APW3++, 93% efficiency, 25C ambient temp)3. Power Efficiency: 0.098 W/GH ±7%(at the wall, with APW3++, 93% efficiency, 25°C ambient temp)4. Rated Voltage: 11.60 ~13.00V5. ASIC Chip: 189 x BM13876. Dimensions: 350mm(L)*135mm(W)*158mm(H)7. Cooling: 2x 12038 fans8. Operating Temperature: 0 °C to 40 °C9. Network Connection: Ethernet (network cable not included)Please note the following:1. Due to the nature of these products, there are higher than normal restocking fees (typically 40%). The restocking fees are typically waived in the event that there is a provable failure within the first 30 days and the warranty has not been voided by overclocking. In the event that you experience a failure, please reach out to the seller immediately so that we can begin troubleshooting with you and/or processing a return.2. Each AntMiner S9 requires TEN 6-pin PCI-e connectors for 12V DC input (must be very stable power source). There are three hash boards that each require THREE 6-pin PCI-e power connectors and one additional 6-pin PCI-e power connector on the controller. All TEN 6-pin PCI-e power connectors are required. Do not connect more than one PSU to the same hash board to prevent possible damage and instability. 3. Power consumption figures will vary with your PSU's efficiency, the ambient operating temperature and the accuracy of the power meter. 4. Power supply unit is not included. Bitmain recommends the APW3++ or the APW7 power supply for the AntMiner S9.
J**.
Buen producto
Buen producto como nuevo. Lo recomiendo
B**N
Great used S9 miners
Miners arrived on time and all functioned at advertised hash rates. Miners were pretty dusty but that is what I expected as these miners are quite old. Price is a little high too.Overall, I would buy from this seller again.
D**K
Great Deal works Great too !
Miner came new, clean, good shipping package, the miner had the firmware and a simple IP login to start mining with my pools added, this was a good deal, will buy again.
B**R
Time will tell
Something was loose but it still works so I’m not sure if that “looseness” is normal. I’ve seen it clock at 9th/s but I’ve also see 19th/s for a short period of time. Average is about 9th/sec not sure if this is a quality purchase but time will tell
L**S
i like this miner
it works well, I arrive in good condition, it does not have the 5 stars just because it has problems connecting from a switch
E**.
Excelente
Excelente
P**L
Worst customer service
Ordered 3 machines from them, 2 work great and the third is defective. Nothing but games and no help in exchanging the unit. Will never buy another item from this seller.
C**R
Buyer Beware
I received the unit with major defects and poor cleaning as the photos show. After receiving my power unit and getting the device up and running it became apparent the device was almost non-functional. Not only did I not even come close to the promised 12.5 TH it also had internal damage which sounds like a loose heat sink. This specific seller sold a DUD and I would avoid them at all cost. After this fiscal I purchased 2 relatively new ones then deal with a seller that promises to ensure the used unit is it as at full operational status but fails to deliver that. This is my updated edit from my original post around 5/15 time frame.
Trustpilot
2 weeks ago
1 month ago