30 SMD 5050 LED Strip Light for Car Trunk Cargo Area or Interior Illumination Decoration, Xenon White, Auto Accessories

Installed in a 2018 Kia Forte. When the package came, I guess I thought it would be larger. It is a small box. The first few pictures compares the size to a few quarters. While the whole package is small, it provides decent light for the trunk. There are no instructions but, it is not too complicated to figure out if you can replace a lightbulb. Here are a few technical details about the product:The strip is about 19.5" inches long. About half way down the strip is a soldered-on pigtail at the 10" mark. The pigtail is about 2.5" inches long.There are 30 LED's on the strip (specified in the product description as well). They are of the 5050 SMD design. LED strip has foam-based sticky tape for better cohesion (as opposed to normal LED strips).The kit comes with two connectors and an extension wire.Festoon type spring load plug and pin type plug. Connectors are 2.5" inches long.Extension wire is 12" long.The festoon bulb is what I had and used the festoon connector. The LED strip is polarity-sensitive, so test which direction the festoon connector should go in.In my case, the existing light was in the center of the trunk, so did not need the extension wire. Everything tucked up into the light socket area when I replaced it. One note of caution, when sticking the tape to the underside of the trunk, don't get it too close to the hole where the existing light facility slides back in, or it could be impacted.I tested the strip prior to install to make sure everything worked (someone noted earlier they had a few of the LEDs not working, in my case everything worked fine).The tape on the LED strip is foam based 3M (at least as labelled) tape. When installed, had good adhesion (unlike traditional LED strips with the paper-think sticky tape). I don't expect this to fail anytime soon.The results were fantastic. As can be seen in the pictures, before and after shots are dramatic (well, maybe that's overkill, but it was pretty cool). This was a great value, and easy project to do. I would recommend to anyone that has a dim trunk light.

The media could not be loaded. I am using this in my trunk. The stock bulb is very dim and doesn’t light up the entire trunk. This led strip is about 6500k in color. It’s much nicer than the previous strip I had previously installed. It’s easier to instal and the adhesion is amazing. Very strong and will be very difficult to move once installed. It comes with adapters for you to use to plug into the existing socket so you don’t have to do any custom wiring. I would like the leads about 2” longer so I could center the light better. Overall this is a great led strip. Output is great!! It lights half my driveway when I open my trunk.

Really bright and way better than the oem lights for the trunk of my Mustang.

Great product so far. I just installed so will update if it lights go bad or malfunction, otherwise good LEDs. Very bright lights and super easy install. The kit comes with the LED strip and two plug-n-play adapters that fit the T10 and festoon style bulbs (one of each). The only this is the wire it self is about 12 inches so I had to extend since I was placing it in the middle the trunk and the bulb housing is on the side. For other applications, like a foot well, this wouldn't be a problem.So far the adhesive is good, but time will tell if it stays on. Lights up the whole trunk so am very happy with these. May look to get some colored ones for the foot wells later.

Needed a better light than my factory trunk light for deliveries at night. Was teferred to this product by another Amazon Flex driver and it's been a good purchase. Easy to install in my 2015 Ford Fusion. Just popped the plastic lens off and popped the bulb out. In its place you put the white plastic capped wire piece where the bulb was and then attach to the light strip. Popped the lens back into the trunk lid and attached the strip for even lighting in the trunk. So far so good...its super bright and makes deliveries so much easier to see. Good buy for the price. We'll see how long it lasts.UPDATE: May 15, light atoped working about 2 weeks ago. finally had a chance to look at it. one of the wires came undone from the strip and I dont or not gonna waste my time trying to have it re-sodered back on. The wiring is think and jenky, so you get what you pay for. it was great while it lasted 2 months.

Was hoping it was a bit longer,as I wanted a full strip for my trunk for a 2001 Honda Accord. The brightness of the lights were brighter than I ever expected, and the length didn't matter at that point. The connection was finicky, but I adjusted for the spade connector. The strip was real 3M, so adhesion was not a problem. Hopefully it maintains adhesion for a while. But it was bright. Would buy this product again in a heartbeat if I get another ride.EDIT:the old Accord has been sold and this remained in her as a surprise for the new owner (she didn't know I had all the lights converted to LED). But I have ordered another one for my new whip. Same issue with the Acura ILX as with the Accord. The trunk light is not bright enough....So, I "improvised"....waiting for the new strip to be delivered so I can install it, along with the other LED's for the internals (Vanity mirrors, rear map/courtesy, possibly the footwells)....Can't really say enough about this one....BUUT, remove the fuse while replacing this tr prevent the multiplexor from burning out (controls the ILX interior lighting...I blew a fuse when trying to replace the trunk light with a different LED)...decided on this product instead....This product has more LED's on the strip, so it is brighter and longer than other strips I have seen, so definitely order this one, folks!