4pcs DIN Rail Terminal Blocks, DIY Splicing Wire Connectors for Circuit Inline 28-12AWG (3 in 15 Out)

Seems to work well hold the wires in place.

I worried about this being an unknown brand, but subjected it to a few retention tests and all is well. I should probably do some tests with large loads, but it's been very reliable with all my +5 and +12 low amperage needs. It is an integral part of the power distribution in a machine I built, and was a huge improvement over the ancient barrier strips that I had been using before. They are easy to use. Would buy again. Photo shows a polycarbonate subpanel that made it easy to handle as a unit in the available space (a 5 volt supply lives in that cut out area)

Didn't use them on a DIN rail so can't attest to how sturdy that setup is, but it worked great for splicing the home run wiring on 24V LED lighting systems.

Works good

Working well in my 3d printer to split out the AC to dual PSUs and AC bed heater SSR.

I love these, I use them all the time

I work for a manufacture of processing equipment so I am always building some sort of contraption to demo products. I stumbled across these and ordered some as I use a lot of lever nuts in my builds, they're quick. These allow me to land and bridge out two connectors multiple times and keep the polarity separated. pretty handy when needing to make a small DC branch or bus. Highly recommend these.

Always liked these wago style connectors. This one is no different and works as described. Only part I did not like or appreciate is the low quality din rail connectors. 2 per connector and all 4 broke while inserting the wires for connecting. I was working with 12 gauge solid wiring but, that should not have caused these din rail clips to break so easily. This was just inserting the wire and closing the locking levers when these snapped.

great item for controller power distribution, easy to use with clean results

Muy buenas clemas para crear un nodo.

Es muy útil cuando requieres varias derivaciones de un mismo circuito