Official 3D Printer Filament Hyper PLA Filament, Creality PLA 3D Printing Filament for High-Speed Printing, Durable and Resistant, Smooth, Dimensional Accuracy +/-0.02mm, 2.2lbs/Spool (White)

This is great filament. All spools have been rolled with no tangles (all that I have used) and my finished product comes out as expected.

Works great with my 3D printer.Thank you.

Filament is great with no complaints.

I’ve been using hyper pla for a bit now and seen this was a bit cheaper so I went with it. When I opened the package it looked like it was wound by hand. I was a bit hesitant to use it but I was doing a large print on my K1 Max and an entire roll was just about gone and needed another. I put this roll on and it seemed okay. I resume the print and some time later I hear a hard snag pull on the filament. I go to check it out and the filament had a damn tie in it! To make it worse it ruined my 13 hour print and couldn’t resume the place because it had continued with there being a tie in the roll. I’m already extremely annoyed because I basically lost an entire roll because this damn thing had a random tie in the middle?? To make it even worse I scrap the print, I cut the piece and untie it. And try to reinsert into the extruder. I’m trying and trying but the damn thing won’t go. I’m assuming a have a clog so I grab my tool and it goes through just fine. I grab a strand of some old hyper pla I had from a previous switch and it goes through just fine. I measure the two and the new roll is way thicker in diameter! To the point I cannot get it to fit through the top of the extruder. The quality control is absolutely horrible. Now I’m out 2 rolls of hyper pla because of this crap!

This filament is near perfect. I've never had a failed print with it. I've used on both a K1 and Qidi X-Smart 3. No jams, just clean strong prints. I run the bdd with at 50 degrees and PEI and the extruder just a few degrees below the max listed on the filament. prints perfect at 250 mm/minute.