26 Pack Unfinished Wood Coasters, 4 Inch Square Blank Wooden Coasters Crafts Coasters with Non-Slip Silicon Dots for DIY Architectural Models Drawing Painting Wood Engraving

Very good product. Default wood is unfinished, some have some bends but not a problem. Any bowing in the wood was fixed after a few passes with orbital hand sander. Most perfect, some bows but again, not a problem if committed to DIY. Good value for product alone as raw material.Me personally, I etched first, then filled with epoxy before sanding flat and then stain/finish/foam feet. No issues at any step of the process, pretty easy. If stain/painting first (no etching), sand it flat first if there’s any bowing before doing anything else and you’ll be fine.I’ve done this process for six of the pack and no complaints at all. Good size, works for any drinks from home or take out, hot or cold.

These are perfect for wood burning and other crafts. Will purchase again.

Great quality great for decoupage

I bought these to use with my laser engraver, they are cheap wooden coaster so don't expect much but they do seem to be a decent product.

I bought these to use with my laser engraver. They are beautiful!

Going to order again.

I have found these to be perfect for my project, though one is warped and one has a large gouge on one side that I noticed after I had prepared it for my project. Some needed sanding and many were ready to use. I would buy these again.

I needed some quick blanks for a customer. Out of 26 coasters I could only use 10. The rest are bowed. If I didn't have to have them I would have sent them back. Will not order these again. Will post pictures later.