📸 Elevate Your Flight Experience!
The Hensych Extended Remote Controller Tablet Holder is specifically designed for the DJI Phantom 3 Standard, featuring a spring-loaded mechanism for automatic tablet fitting. It supports tablets ranging from 11 to 18.5cm, is made from durable 3D printed material, and boasts a detachable design for easy transport. Note: Remote control and tablet are not included.
C**R
Great product
Great product - I'm glad somebody made this as all other tablet mounts I tried are rubbish. It doesnt get in the way of controls or antenna and holds firmly. No much wobble, but my criticisms are that it could fit the remote slightly better because it can move up and down a little (though it is not a problem). This is easily fixed by adding a foam pad on the opposite side of the blot from the tablet underneath as this presses the mount against the controller. Also there is no way of fixing the tablet clip properly (it just slots in) so it could fall out if held up side down. I personally glued it and just remove the whole thing each time. Overall, very good and I would reccomend it. I used mine with a NVIDIA Shield tablet.
M**K
Good tablet holder
Good tablet holder. Fits well to my phantom 3 standard controller. I have a samsung tab pro 8.4. It looks as if the holder is a 3d printed item.My only moan for want of a better word is that the top and bottom of the holder could do with some fabric material, because the holder is plastic and the tablet is plastic/metal and glass it does tend to move around a bit.I've found that if you have a sun shade for your tablet the holder grips the two better than without.
A**H
Not Brilliant
Does the job, but it wobbles after a short time as it relies on one screw. I have to keep tightening.
H**H
Four Stars
Could do with better padding, which I added but otherwise its ok and hold the ipad mini fine
T**M
Top piece comes off so easy to store and carry as it narrows it back ...
No other products on the market that actually fit the phantom 3 standard controller to hold tablets. This simple 2 piece kit allows you to fit to the 3 standards controller without the drilling your controller hack. Top piece comes off so easy to store and carry as it narrows it back down to no bigger than just the controller on its own.
M**N
Needs to be stronger
Fits well and little wobble but because it is a 3d printed product it is extremely weak and already cracked in places and will not last
A**R
Weak unit
Disappointed with this item, wasn't strong enough to hold a tablet
N**E
Brilliant
Brilliant for holding my iPad easy to fit
Trustpilot
2 days ago
5 days ago
