Spigen Screen Protector Matte for Tundra, Sequoia, Tacoma, 4Runner 14-inch

I've used Spigen iPhone covers on my last 3 phones and they work, fit, and last the life of the device. After buying a new Tundra with a 14" touchscreen control panel the fingerprints and the glare on the screen while driving were an instant issue. When I found Spigen sold a product I was all over it. Excellently packaged, super easy to apply with the tools provided. Installed in just 5 mins. and was a perfect fit. Bubbles smoothed out easily. Finger prints are almost undetectable. Glare is gone. Touch screen sensitivity not impaired in the slightest. Screen resolution and definition are not reduced at all from the matte finish ( something I was worried about ). I have no doubt this protector will be a one-and-done purchase protecting my display for life. Good value too !! Thanks again Spigen.

Quality item. Easy to install with provided tools, cleaner and cloths. It does cut down on the glare from screen making it easier to see. Taking extra care to clean glass and time to position the screen helps in making installation go smoothly. Scraper provided does a good job of removing the bubbles that get trapped between the glass and screen.

The install is fairly straight forward. Took a minute or two to get it lined up just right, but I'm also used to smart phone screen protectors now that are basically cases you put on the device and just push and the protector is installed. But it fits the area well and is fairly easy to maneuver by lining up the top and adjusting from there before pressing on. I had one bubble at the top, smoothed out real easy. There has been very minimal fingerprints on it, you really have to have non-washed hands to get it looking greasy. The anti-glare works well so that the sun isn't shining so bright, but it does dull the screen every so slightly. I like a nice vibrant colorful display and this just cuts a little away from that.

Fits perfectly. Installation was pretty straight forward. Need to be aligned just right or edges won't sit right and you'll get air bubbles. Otherwise works great.

Easy to install on 2025 Tacoma with the 14” screen

Another quality product I've come to expect from Spigen. The matte finish was perfect for my needs and the glass is the protection I was looking for. A couple of installation comments. One, the plastic tabs to help with the installation are a bit fragile. I did a few "test installs" to help get the process down before the actual application. In one of those "tests" one of the plastic tabs broke off. So, be careful they're fragile. Also, because one of the tabs fell off my install was less than perfect. Huge air pockets I couldn't work out. I grabbed one corner and peeled it back carefully until one half of the glass was lifted off the screen and then reapplied. I repeated the process with by peeling back the other corner diagonally (catty-corner) from the first. It helped get all the air pockets out.

Screen protector went on easy and will protect the screen just fine. My problem is with the matte finish. It looks great when there is no direct light. But if the sun is behind you and shines on your screen then it just turns white. Makes the display unreadable.

purchased for 2024 tundra. I never thought about a screen protector for the touch screen in the truck, but saw this product. Comes with 1 screen protector, I dry fit it before cleaning or peeling to see where the edges would be. The protector is a perfect fit for the screen, edge to edge. used the wipes and the dust sticky, it takes time, don't skip this step, big screen but worth it to avoid fingerprints and any dust particles. I did not use the hold tabs, they seemed flimsy just started on left side and peeled as i went, it did have 3 small bubbles after using the tools to remove. After 3 days bubbles are gone and protector looks great, it is anti glare, and the touch sensitivity is fine no issues. great add and would recommend.