Custom Skull Front Grille /Tailgate Emblem Badge 9''x3.5'' Compatible with Ford F150 F250 F350 Edge Explorer (9'' Red)

I watched a couple excellent videos of removing the front emblem and the rear emblem. I then used my vernier caliper to check measurement and realized you should not attempt a front mount. Especially when you see the method of grinding out the rivets.The rear emblem on the tailgate is a flat surface to mount it too. However, instead of a heat gun as shown in the videos online, use my process. Took about 15 - 20 minutes start to finish and there is zero destruction to the Ford emblem.After removing the access panel in the tailgate, use pliers to crimp closed the four retaining clips that sit proud of the sheet metal tailgate. Then insert a solid piece of wood to span the two long pins. Put something on the ground to capture the emblem should it fall free while pushing.The emblem has an adhesive seal that is there for moisture protection. Once the four retaining clips are free of the sheet metal, raise the tailgate and carefully pull it off the adhesive seal.Using your fingers, carefully pull / roll the adhesive seal, clean the painted surface and using the calibrated eyeballs in your head, carefully position the adhesive backed punisher skull. Once you are happy with the positioning, press very hard to bond it. I was able to remove the emblem several times to get it perfect.

It looks good for a flat emblem. It goes on with tape not screws. It's aftermarket good quality not a OEM looks but it's aghight.

Looked great however the picture does not show this as being flat. This emblem is flat, unlike the stock badge in the grill and tailgate. It also lacked the mounting clips that secure it to the chassis. You are completely at the mercy of the adhesive that comes with this. I liked it, it was just not right for the application.

It doesn't fit in the space the ford emblem goes in. A total waste of money