5-Feet Cable Blanket High Capacity Low Profile Cord Cover and Protector, Beige

I’m a teacher in a classroom where I wanted a layout that meant I needed to be able to safely walk over a power strip cord, AV cable, and two Ethernet cables. Not many cable protectors can hold that much, and if they do they are REALLY bulky. I’m a klutz, and I knew if I had a speedbump like that to go over I would be tripping CONSTANTLY.I was delighted to find this, although (remember: teacher!) I was put off by the price, since you can’t really reuse this year to year (we have to clear out rooms so they can do deep cleaning each summer) because it is adhesive.So to save money I decided that 2.5 feet would be just enough (you can see I could have used another 6 inches or so in my pic above!) so I cut the roll in half.I’ve now used that roll up over the past 2 years, and I ordered the double pack which will last me 4 more...this thing is great!The adhesive was surprisingly durable, despite frequent traffic, and occasional roll-overs with my desk chair. It didn’t damage the short, institutional school carpet either time, and it let me really squish down those cables really, really flat.This is a great product!!

Works exactly as it should. I had some wires that I needed to secure so it wouldn’t be a trip hazard for me. I couldn’t decide between grey or brown, but I went with grey. Our flooring in the office has both shades of color in it, but I feel like the grey was a good choice. It’s been about 2 months since I installed it, and the adhesive that it comes with has worked just fine. No complaints here.

i like the gray color, i also was happy i finally found something wide enough to fit my cable wires that are on my floor, i have wood floor tiles and the cord cover stuck nicely to the my floor. i would say its a good buy although i didn't care for a very small portion of the sticky part didn't work so now a little piece is not sticking to my floor and sticking up instead.. other than that its a great product and very easy to install

This does a good job of covering the cable I put it on, and its color is close enough to that of the hardwood floor not to be too much of an eyesore.But the adhesive is worthless. It stuck for a few months, but ever since then, it has spontaneously peeled itself off the floor, allowing the cable to slide out from under the cover. It seems that it never fully "recovered" from being coiled up for shipment, so there's a constant bending pressure that just pops the adhesive off the floor over time.We have this covering an audio cable that's running across the floor, under an area rug, so I cut it into two pieces, one for each side of the rug. It was easy to cut at the angle I needed, and it was easy to place on the floor Since we're just protecting a single stereo audio cable, the protection it offers *would* be adequate if it would stay stuck to the floor, so that the cable didn't come out from under it.

It blends in with my deck and hides the cable. The attached sticky product did not work and I had to apply a different double side tape.

I was an unwitting middle man between the seller and landfill. There are several things wrong with this product. 1) There is barely room for two cables. I have a 220v and 115v cable that need to be covered. However, the profile of these two cables barely fit in the cavity designed for the cables. 2) The tape backing on the adhesive was inconsistently covering the adhesive. Looks like it was displaced when the cover was rolled up before being boxed. 3) The adhesive was inadequate to the task. I cleaned the surface of dust and debris before trying to lay down the cover, but the adhesive did not adhere to the material of the floor. The floor in my shop is similar to brick in composition but seamless as it must have been poured and then smoothed out. Probably not the best material to glue to, but it did not stick at all. Anyway, don’t buy if you have multiple cables of above average size or a bare concrete or brick-like floor.

Covers my speaker wire perfectly. Easy to cut to fit.

In theory, this is a nice idea (hence, the 2nd star) - to have a cable cover with potential for variable height to cover a variety of cord thicknesses and numbers. The problem is that the execution is terrible. The adhesive is inadequate to hold to the floor, and within minutes, it comes up and looks worse than nothing at all. Believe me, I cleaned and dried my floor several times before trying to apply this,s and it was pristine, but the poor quality adhesive made it impossible. It is not inexpensive either, so I recommend trying something, anything, other than this item. Very frustrating.