Cement Resistor,10 PCS 10w 150 Ohm 5% Axial Lead Wire Resistor White Wound Fixed Ceramic Cement Resistors Wirewound Cement Power Resistors Flame Heat Moisture Resistance Precharge Horizontal Resistors

On my Surburban, After rebuilding engine, the KNOCK sensor code came on about a week 2-NEW A/Zone sensors were installed. Aftermarket sensors have made me resort to OEM in the future on ALL sensors. To remove UPPER PLENUM to return or put OEM sensors in is normally a $300 labor operation. These 2K ohm resistors soldered in place on the harness right before going under the intake is the desired resistance value to FOOL the engine computer and put my check engine light out. I surely would know if engine is tapping or knocking without the engine computer alerting me. This is the FIX to put the check engine light OUT without REDO labor operation.

I use these to discharge large capacitors. Enough said. Works like a champ.

Working great for me

Well within tolerance for rating, good price

Clearly out of spec and probably why they are so cheap, but good enough for my purposes.

I appreciate the on time delivery and good quality resistors. They did the job I needed.

Measured very close to spec on the DVDM. They powder a bit on the underside from manufacture but this really is no problem

I needed to add resistance to a lower-resistance, center-channel speaker, because the R and L floor speakers were 8 ohms. I had previously tested out several series-resistances in a temporary fixture and 3 ohms gave the best sound balance. I purchased these multi-watt, 3-ohm resistors with "cement" potting/cooling and they were within 5% of 3 ohms and they can handle the power levels (actually the drive current of a few amps, peak, not continuous) that I need.These were obviously hand-filled and show variation in the filling (see photo). Good enough for what I needed.