Woodworks Pergola pergola Brackets 3-Way Right Angle Corner Bracket DIY Elevated Wood Stand 4PACK with Screws for 6x6 (Actual: 5.5x5.5 Inch) Lumber Pergola Gazebo

I cut my horizontal pieces at a 90° angle so both could have at least a triangle of an end sitting on top of the vertical rather than pushing the vertical all the way to the top of the bracket and then trusting the bracket to hold the horizontal to the sides of the vertical. That ended up being a good decision because I put one horizontal and two verticals together laying on the ground and when I put those two verticals up there was enough torque on the brackets to crack them. Even if it's easier to assemble some of your posts on the ground before you put them up in the air I would recommend setting your vertical posts individually and then adding the horizontals into the brackets one at a time. The metal is just too thin of a gauge to be able to handle any kind of twisting that might happen if you assemble anything on the ground and then try and stand it up from there.

They Fit perfectly on dried 6x6's, but had to grind down a tad on fresh 6x6's. They are sturdy and fantastic for the price. Screws are small, had to replace with sturdy lag screws.

The corner brackets have cracked already. Still functional ok but if I was repurchasing would not go with this kit again.

Item definitely wasn’t the right size as it said. Had to trim the 5.5x5.5 lumber in order for it to fit into brackets. Would of been too much hassle to send back since we already bought all the wood.

We had a couple of the welds break and one side was not even welded together!