Loctite Epoxy Instant Mix 5 Minute, 0.47 fl. oz. Syringe (Pack of 6)

Easy to use. Not a lot of pressure required to deliver the mixed fluids through the special syringe tube. Used it on a sockslide which is supposedly made out of ABS plastic. It's been working just fine, the glue is holding very well.

I can't speak to other applications but this was exactly what I was looking for. I needed a strong epoxy which would flow well into crevices but was thick enough not to run all over, this is about the consistency of cold maple syrup upon dispensing but hardens within a few minutes to tacky and then starts to solidify. I had a barrel shaped wiring harness with a number of wires close together, which would move and touch each other at extremes. I applied the epoxy to the wire ends, which were soldered in place, and then wrapped tape around the area to make a tube and then filled the area to make a solid epoxy plug. I did it once and let dry for a few hours and then did the process again. The result was exactly as desired, all the wires are encased in epoxy and the strain relief slides over the epoxy plug. The epoxy resin cures up very hard in 24 hours but it does not seem to be brittle. It fills gaps well and is not difficult to work with. If I was using this for any other application, I would ensure the work I wanted to connect was sanded and de-greased, to provide the epoxy something to grip onto. Perhaps this is the problem some folks are having who have rated this product low. I found it perfect for my needs.

No tools required, great size for getting nozzle into hard to reach places. Syringe has a snap off top and the nozzle screws onto the syringe. This joint is pretty shotty and can blow out if you apply too much pressure. Gentle pressure and ensure bracing or pressure of glued parts, a blow dryer speeds drying time. Great glue, crappy syringe.

Working is great

Stuff works like you nailed it down.

This product is a chap alternative to other epoxies, but that is reflected in the product. The hardener is not effective and must be mixed manually, the stick is not strong. The strength is reduced compared to other epoxies, and after the solution has dried for several days, it is still sticky and not very strong. The product advertised setting in 5 minutes, however, it takes several hours for it to react and finish. The black push bar makes it easy to apply with little force, but do keep in note that it will be hard to push at first, and then after the epoxy starts moving it becomes a lot lighter to push and asker to over apply. I found it handy to start pushing and stop right after, and slowly apply more incrementally. PLEASE, PLEASE, do this is a WELL ventilated, before this dries, epoxy fumes are TOXIC, especially to people with asthma. This product is good for light, hobby crafts, as the price is good for that, but it should not be used for anything critical or beyond hobby crafts.

(*Updated on 26 Feb '23*) I've used this on about a dozen (maybe 2 dozen-ish) different projects since I purchased it about 18 months ago and used it on different craft mediums. I've come to the conclusion that the only con is what I wrote when I purchased it: It takes longer than 5 minutes to set (ie set enough to not have to hold pressure yourself). A few pointers: 1- Purchase this product. (No, really. Purchase it. It's THAT good.) 2- The colder the product, the more difficult it is to work with. As such, trying to push it out with the "syringe"/plunger proves to be frustrating. 3- Immediately after you apply the epoxy, before you even adhere the objects together, pull backwards on the epoxy plunger. This will, so long as you pull the plunger back far enough, prevent the epoxy from spilling out of the tip and gunking up the lid. 3- (No time recommendation here) Use a warm, wet ("wrung-out" wet not dripping wet) cloth to clean up any tip seepage before you close the epoxy "syringe". 5- Give a shout out to Dr. Sylvan O Greenlee for inventing liquid epoxy. 6- Use the epoxy. 7- Run out of said epoxy. 8- Repeat Steps 1 - 7 as needed. (Original review directly below and prior to the 26 Feb '23 update this had a 3/5 🌟 ranking. Update includes changing that to a 5 out of 5🌟s.) Pro: A little goes a long way Con: It takes longer than the 5-minute set time it professes. TIP: If possible, clamp your pieces together to ensure successful adherence.

I needed to repair a split leg on a side table. It is used in the family room, so it needs to be durable. I live in Hawaii, so humidity has to be a big consideration. That made epoxy the "go to" product for my project. I have never worked with epoxy before. I have been intimidated about getting the correct balance of epoxy and hardener. That made the idea of a "self-mixing" tool ideal. The instructions are pretty basic - also very straight forward. I did have to fidget connecting each piece, but that was due to my lack of attention to physical shape of the syringe and nozzle connection. The fit and turn instruction is easy enough to follow, if you look at the design of the nozzle end. Once it clicked (literally), the nozzle worked perfectly. The dual syringe is compact enough that you can control application very easily. No mess, no fuss! Well, the only mess was due to my inexperience. But it was easily addressed and cleaned. The instructions are pretty basic, and fairly straight forward. If you do what the instructions tell you to do, it's not a problem. The label says "translucent yellow." To my perception, it was clear from start to finish. The solution worked smoothly and adhered well in less than five minutes. I clamped the joint and left it to sit overnight. Today, the table is back in place and the only evidence it was ever broken is a small hairline "scar." I would absolute recommend this product.

Takes a full day to set but works great for fixing artificial jewellery

Muy buen pegamento, muy buena calidad, solamente que es muy difícil volverlo a utilizar ya que, aunque quites la pipeta y le coloques la tapa es dificilisimo volverlo a utilizar. Hay que dejarlo secar por lo menos 12 hrs y listo, transparente 👍🏻

Its not that strong glue what i expect to be , but is doing the job.

Quickness of sealing Used to attach metal lamp to cement base.

Sehr zu empfehlen. Gut für unterwegs.