Carburetor for Briggs Stratton 791077 696981 698860 790182 694508 795069 698859 790180 790290 693865 697354 Craftsman Tiller Intek 190 6 HP 206 5.5hp Engine 120202 120212 120232

Easy install, just matched up the choke parts to the ones that looked the same as the original carb. Primed fuel by loosening the plug on the bottom and retightening it, the engine started on the first pull.

Bolted it up hooked the gas and pulled it over a few times and my tiller is up and running again.

This was a custom fit for my motor. Very easy to install and worked perfectly. Price was great also.

It works and fires up but it doesn't like to stay running and bogs down under small loads now when original carb did not have that issue. The problem is this carb us non-adjustable and there is no way to make it adjustable. Original carb could be adjusted with the right tools. Unless you are living within 200 feet of sea level, don't bother. Carb is well made however. Just a design flaw.

I was real pleased with this. It seems well made. It came with all the gaskets, screws, etc. needed. It included some extra parts so it would fit various engines. It installed easily.. Engine started right up. Old carb was completely clogged up. Lesson learned: put stabilizer in your gas, and run all gas out of tank/carb before storing for winter.

I mistakenly left gas in my Husqvarna Model # 020524 pressure washer and the carb was all gummed up and would not start. This has a 250-cc Briggs & Stratton 1150 Series™ OHV engine. Spent 6 hours cleaning tank, fuel system, and carb. It would run with choke on after the cleaning. Instead of wasting more time I ordered this carb (sure is hard to find correct parts). I replaced the carb in 15-20 minutes along with new fuel line and inline filter. It fired right up and have used the pressure washer for more than 15 hours since the replacement and it runs like new. I will remember to use Stabil in the future as I typically do.

I've been working on an Intek 206 motor on an old Craftsman RT5 tiller for a few weeks before figuring out the old carburetor was sticking. Bought this carburetor and now it cranks up right away. Instructions would be nice but I suppose they would vary depending on what motor you put this on. Thank you to reviewers who said that the foam ring is to be placed on the choke. I would have never figured out where that was supposed to go since the old one didn't have that.

The first time I tried starting engine with the new carb, it totally flooded. Able to clean bowl and engine started right away. After a couple days not using, the carb flooded again and again got it fixed. Now, after a week of now using- engine will not start. Cleaned carb again, still not starting but will run for a bit only with starting fluid. Was going to give it a 4 but not sure now.