Solar Panel 100W 12V Lightweight Semi Flexible Black Division Monocrystalline Bendable Mono Off-Grid Charger for RV Boat Van Car Uneven Surfaces, LTWT-Flex

Slightly larger than my ecoworthy panel but seems to work well and was easy to hang on the roof of my duck run. Has good power output it’s super lights and has some flex to it which I needed with the rounded roof.

The original order was lost by Australia Post - but - Renogy sent a replacement via a different carrier. They were more helpful than Amazon. The panel is a replacement for a 110W flexible panle and the Renogy 100W has greater output - VERY Happy with it.

The panels perform well seem durable and are flexible. I’m very pleased with them. They fit the bill for my application. Small amounts of shade do not seem to significantly impact the panels’ output, unlike some i’ve used. I needed low-profile flexible panels to fit on my truck’s topper, between the roof racks. The size of the panels are a perfect fit, and allow 2 to be installed on my roof. I wanted the installation to be easily removable, but to also easily handle highway speeds without me worrying about panels flying off. Utilizing the grommets on the panels allowed me to use M6 tee nuts and M6 machine screws and 1” M6 threaded plastic knobs to hold the panels in place. The grommet placement on the 2 panels I received were identical. I fit the machine screws through holes drilled in the topper. The screws (and large washers) are on the inside of the topper, with the tee nuts on the outside. The screws and nuts are snugly tightened, which allows the plastic knobs to be loosened and tightened without someone inside the topper holding a screwdriver to keep the screws from loosening. I used RTV to seal the holes, which also helps hold the screws and nuts in place without turning. I’ve used similar combos on truck toppers for 30+ years and have never had water leaks. I also attached heavy duty velcro around the edges of the panels, and attached velcro to the topper. The velcro alone holds the panels very well, but I wanted more security for highway speeds, hence the tee nuts and machine screws. I also put a “carbon fiber” looking vinyl wrap on the topper where the panels fit, for abrasion protection. Insulation can be placed under the panels to insulate the topper from the panels, which can get hot. 5 mm foam insulation is what I use.

received on time and in good order. Have not used it yet but looks good quality and I am confident it will do the job charging my lithium batteries.

I'm not using it for it's designed for application, I use it to keep a parked vehicle's battery topped off by placing it inside the windshield. I had to trim the edges just a little bit to get it to fit, but it fits like a glove now. I have all of the necessary controller circuitry and it keeps the battery in a perfect state of charge. Even cloudy days it generates more than enough for my needs. I do not see the claimed wattage output but I knew that going in I never would with it inside a windshield and in a fixed position. There are smaller cheaper units sold for specifically this purpose but I found that they were not enough and depended a lot on the weather being clear and sunny. This one just works all the time.