APS Running Boards (Nerf Bars Side Steps Step Bars) Compatible with Ford F150 2009-2014 Regular Cab (Stainless Steel Black Powder Coated 5 inches)

The body of my 2014 F-150 STX Sport Regular Cab is in great shape but the factory running boards were rusted, pitted and ugly. Bought these to replace. Surprisingly, the originals unbolted easy enough.After digesting the instructions the install was straightforward. Everything lined up as planned. Look good like they belong. Set slightly higher then originals but a bit wider so make for a comfortable step. Note: some hardware packed inside rails; when installing clip nuts in opening hold firmly with pliers...using just my fat fingers I lost one then spent 15 minutes finding and fishing it out finally using a telescoping magnet.

Have been driving my 2011 F-150 for eight years before I finally decided to add running boards. Getting older and dealing with knee issues helped persuade me to spend the money and I am glad I did. They were not very difficult to install, I did these myself, and look nice. Much easier to get in and out the truck!!

Laying on the ground under the truck installing this thing, I got rust in my eyes from the pinch weld on my 2010 F-150. Wear safety goggles. Other than that, installation went well. I weigh 150 lbs and can stand on it without too much movement, even though the pinch weld is almost rusted away to nothing.

i am a big guy and these are quite sturdy. they look just like the steps that came on my newer truck from factory

Fit perfectly on my 2014 Ford XLT F150 4x4. I considered the 4" running board, but decided to go with the 5" instead. Glad I did. The 5" is just right for stepping in and out of the truck, the 4" would have been less comfortable. Good quality materials and installed easy. The only thing that would have been nicer is the bolts are just generic silver bolt like you would buy at a hardware store. They will definitely rust. The bolts should be black or stainless steel. Since the running board is all black the shinny silver bolts ruin the look. The second thing that would be nice is if they had a plastic skirt between the rocker panel and the running boards to help debris and road spray off. I plan on making my own skirt for it. Other than my suggestions I am very pleased with the iBoard.

Well packaged and instructions are very good. Instillation brackets fit perfectly and boards appear to be well made. Like the 6 inch. I can actually use the back end to reach things in front of bed. Replaced round type steps that were slick when wet.Previously commented that I couldn't attach the front bracket around the brake cable. After looking again, I realized I could move the cable enough.

Look good

Easily installed and helpful in getting into or out of high off the ground trucks.