Clutch Cover Pin Kit Quick Release Tool compatible for Can Am Maverick X3 2017 2018 2019 (Pack of 11)

Pas encore installé mais l'ensemble semble être correcte.

I wish it came with type of install tool to help tight them. I used a small screw driver to place in the small hole of the screw to tighten them in. I think it needs a washer between the cover and the pin to help seal better so water don't get in. Other then that not to bad to install and rivet the on the cover. Fits well on 2020 Canam X3 RS Turbo

So much easier to remove the clutch cover to clean out and especially for a broken belt on the trail. No tools needed to remove once these are installed. Highly recommended!

These make changing the belt on the trail or in the dunes so much quicker. Dealing with the factory bolts is a PITA. Install can kinda be tricky getting everything to line up but these are definitely a must have next to a quick change belt tool.

First off there are no instructions. Granted if you buy this set you already know you are at least slightly mechanically inclined enough to figure it out or know someone who is. Next description says black rivets which cool they will blend in but they are not black. I ended up using a 4.0 rivet and larger washers because the ones sent seemed so danty. If you don't own a rivet gun buy or borrow one they are same price as this set for a cheap one. The WORST part of this set is trying to screw the pins into clutch housing. I started by just using Allen wrenches to turn til tight. Then put clutch cover back on but pins were still really far out tried tightening more with Allen wrenches after breaking two smashing my knuckles I ended up drilling through a socket and cut an Allen wrench to fit in as a key (see attached pic of set up in use) with clutch cover on I used set up to tighten as much as I could then removed cover and had to use set to make 1 full turn on each to make sure cover would hold tight and seal properly. Right after I messaged a friend I ride with he said another person we ride with has tried these and they ended up loosening up and letting water and dirt into housing. I don't feel like I'll have that problem being my cover is pretty snug but it was a task to do so with no tool or instructions on how to. Just gotta wing it.