316 Stainless Steel 12V Hidden Flush Mount 5190512 Marine Boat Horn Two Hole Installation Spacing of 114.3 mm

This horn was very easy to install and loud enough to let other boats know your there. It works very well.

Slightly bigger than standard marine horn. Had to trim fiberglass to fit. Over all no complaints, has held up after a month, hopefully it stays that way

This horn was a direct replacement for my horn that came on my Four Winns boat. It has a really nice and solid tone. Thank you for a great value and quick shipping on a nice sounding horn.

Bought a new to us pontoon. Fit great and dud the job!

Got exactly as ordered, horn with Stainless Grill. Ordered the Fiami and they sent a plastic one as so many in the reviews stated, these guys send what you order. If you have a Sea Ray the grill and horn is larger on all sea rays and you will have to use the original grill and modify this horn fitting, after a bit of work it fits and works fine but for some reason its smaller than most OEM fittings

I had my carpeting replaced with vinyl in my pontoon boat and chose to place a horn in the console rather than drill holes in the new floor. The new horn required minimal cutting in the fiberglass console, resulting in easy attaching and wiring. Sounds like a car!

I purchased the horn, there were multiple of the same horns available, most all of the other ones included hardware, this one cost the same or slightly more, but had no hardware, just the horn.

works great

They was a quick swap as it was identical to the old one I was replacing. It sounds loud and works as it should.

Decibel level is as advertised and loud is what you want.It was larger than the original horn so I had to carve out a little bit for fit. Would have been nice if they had provided a template.so be careful if you need to do this, go in small steps. Seal well with silicone adhesive. No mounting hardware provided either.Looks great, let’s see if it lasts.

GOOD REPLACEMENT HORN RECOMMEND THIS PRODUCT.

Ordered this to replace an existing horn on my Sea Ray. Although the outer plate was the same size, the circumference of the horn itself was much larger. NP though, was easy to McGuiver without any cutting, simply used the supplied bracket and installed onto the underside of the anchor compartment.Works fine and is safe from any water damage.