Sylvania LIGHTIFY ZigBee Adjustable White 12" Convertible Under Cabinet Light, Works with SmartThings, Wink, and Amazon Echo Plus, Hub Needed for Amazon Alexa and The Google Assistant,71148

Very easy to install and setup using the SmartThings app. Hardwired into an existing outlet below, all I had to do is run wires down the back side of the wall to the outlet. I was lucky that on the other side of the wall it was open to run the wires. So if you're retrofitting an existing kitchen it might be a little tricky to run wires but if you have a way to wire it this is a great light?

The good: bright, dimmable, color temp from daylight to amber. When it works, it works.The bad: no ZigBee documentation, one in five had a bad ZigBee chip (the 18"), and the 12" can be reeeeal tight to wire in. The little plastic inserts that hide the connector ports fall out easily. The hex nut that holds the strain relief connector is annoying to install and tighten, and if it isn't rotated properly it prevents the case from sliding back over the top.Note to anyone using your own ZigBee stick: To initially connect, just add power. To reset, start from the on position. Now turn off the light switch, turn it back on. Count to three. Repeat 8 times. After the final time, wait up to ten seconds and it should blink a few times and then pair.Overall I recommend it (I bought five of them, three 12" and two 18"), but it would have been nice if it came with ZigBee documentation and if the 12" wasn't so painful to fit wires in.

I purchased 2 of these lights. My smartthings hub will not discover them.I have over 30 smart devices on my hub and have done this for years. I even tried hard resetting the lights. No luck