McAlpine V33WM Twin Connector, White

Facile da installare, non ci vogliono utensili.comodo il fatto che i 2 tubi di scarico,sono orientabili a 360gradi. Il diametro é 40mm.

Non conforme à la descriptiln

Con solo una foto y una descripción tan pobre puede que no sepas lo que estás comprando. Yo lo quería para desagüe de dos lavadoras pero no vale porque tiene una agujero en el centro. Añado foto para que otros no les pase lo que a mi. Le hago el trabajo al anunciante.

We have just moved into a house with a utility room, it needed the plumbing adapting so we could fit a washer and a dishwasher but there was only one cold feed and one standpipe with a u bend. I bought and fitted a brass splitter for the cold feed issue, I got it from Amazon. It was really advertised for splitting a garden tap onto two hoses. A bit of plumbers tape on all three threads and it works great, not a drip at all. The standpipe was the bog standard Type but covered in emulsion, cleaned the off an recut the top properly square. Cleaned off the burs. Fitted the McAlpine on top(made sure top of pipe was in excess of two feet(60cm) high.Tightened it onto pipe and nipped up the brackets to ensure pipe well fastened to wall. The pipe is vertical. Pushed washer waste pipe onto one horn (made sure it was very well seated) Pushed the dishwasher waste onto other horn (dishwasher waste tube was slightly larger than washer tube but horns are multi thickness so a good fit for both. Nipped up nuts on both horns for best angle to avoid pipes from nearby combi boiler. The McAlpine works great, no leaks and even my ham fists didn't cause a problem. The item is very well designed, I worried about the previous bad reviews and the possibility of the vent hole leaking. I looked at the item when it arrived and it was obvious that the waste water enters the horn, into the waste pipe and is deflected down. The vent hole at the top is like the small end of a funnel which totally prevents the water splashing up but provides the necessary air hole to stop a reverse syphon back to either machine. All in all a good bit of kit if used on a standard stand pipe with a u bend. It is not designed to be fitted on its side or in a sink waste, but why would you do that?

Habe einen doppelten Abflußadapter gesucht, der in einem Neubau an den geschraubten Abfluß mit einem einfachen Anschluß passt. Im Umkreis hatten sämtliche bekannten Baumärkte keinen entsprechenden Adapter im Programm. Der Schraubanschluß war im Durchmesser stets zu klein. Also habe ich den McAlpine Adapter gekauft, obwohl keine Größenangabe für die Überwurfmutter angegeben war. Der Adapter ist sehr gut verarbeitet und passt 100 % an das vorhandene Abflußrohr. In den zweiten Anschluß habe ich den dünnen Abflußschlauch eines älteren Miele Kondenstrockners hineingesteckt, weil der Innendurchmesser zum Aufstecken zu klein war. Anschließend habe ich den Anschluß mit selbstverschweißendem Gummiband umwickelt. Ich bin mit dem Adapter sehr zufrieden und kann ihn nur empfehlen.