Brewster InHome 99432 Spectrum Window Privacy Film, Tranparent

This film is fairly thick, which I think made it easier to work with. I unrolled it and weighted it down until it no longer rolled back on itself. That made it a lot easier to measure and cut. I used about 10 ounces of cold water in a spray bottle with 3 drops of Dawn dish detergent added. Spray the window very generously, peel the backing off the film and place it on the wet glass. Once the film is approximately where you want it spray the outside film surface. We first gently wiped the bubbles to the sides of the film and then used a small squeegee to remove most of the remaining bubbles. We also used one of those small, flexible squeegees that you use to install the screen protector on your phone, followed by using a credit card to coax out the last of the bubbles. I thought it would be better to cut the film a little wider than necessary and trim off the excess, but I wished that I had measured out exactly the width that I needed. It was so easy to slide it into place that if I didn't need to trim with a mat knife it would have been a 5-minute install once it was cut to fit. We installed the film on a clear sidelight and now it looks like reeded glass. Our goal was to block the view into the house without losing the light. This product definitely solved that problem. As thick as it is I expect that it could provide some insulating benefit as well.

I have been on a quest to find some film that looks like reeded glass (the glass with wide vertical ribs reminiscent from the 20's & 30's). Some of the pictures and reviews gave me hope that this would be such a product. And it is, provided that you have terrible vision and it's dark. Since I was unable to find another alternative, this will have to do for now. At a glance, it doesn't look bad, but it does still look more like window film than frosted or patterned glass.Installation was pretty simple following the instructions. As another reviewer mentioned, you do need to cut it to size before attempting to install rather than attempting to trim it once it's in place. For the price and convenience, I can't really complain, though I will still keep an eye out for a pattern that is closer to what I've been searching for.

Ordered two of these for my back doors. I've installed several other brands window film. This one thicker and a little harder to use than others. 1st thing is I followed the directions based off of everyone's problems. I only used water and did not use soap which is very odd but I figured that's why other users had an issues with the film falling down later. I used a very firm solid squeegee with a fair amount of pressure. I don't see any major issues. I did leave about an inch of extra material on three sides and trimmed with a razor blade after I had it roughly in place. I then squeegeed for about 15 min per window.Overall it looks nice but its more opaque than I expected. The film is made in Germany and has a grid on the backing paper for easy cutting.

We are doing a kitchen renovation and there really isn't money left in the budget for window coverings. Privacy is a must. This window film gives us the privacy we need and easily fits into the budget.Installing/ applying the film to the windows was VERY easy. One tip, make sure the film is completely trimmed- the film will begin to pull away (no big deal, just reapply).I would recommend this to anyone that is looking for a window covering solution. Inexpensive, added privacy, easy installation, clean.

This product looks great! It just would NOT stick to the window. I tried every trick. It would stick for a minute, long enough for you to see how great it was going to look, and then start curling (even after I soaked in hot water and rolled in the opposite direction). Don't bother.

I bought this privacy film, because we started to get mold build up on our bathroom windows right behind the small curtain that covered them. But we also had a privacy concern, our bathroom faces the street and taking the curtain off also meant letting everybody look into our bathroom....So my wife found this product and so far, it has done a great job at keeping the bathroom well lit with natural sun light and very private at the same time.You don't need glue to stick this film to your windows, the product doesn't have any type of adhesive for that matter, it uses moisture. Simply, measure and cut the film to match your window, make sure the window (s) is clean, then spray some water onto the surface of the window, and apply the film; once on, you'll need a squeegee, but since you probably don't have one, I know, 'cause I don't....simply use a credit card to squeeze all the bubbles out and you're done. This film gives windows a foggy look, which will block sun rays, but will also let the room be lit, cutting on energy costs. The film won't allow strangers to look into your bathroom or whatever room you're using this in, I checked and could only see white shadows.After almost a week of constant showers, the film has remained in place, without peeling, not even a bit. I highly recommend this product, but make sure you spray a good amount of water onto the surface for a better grip. Good luck.

It was easy to use, compared to other static films I have used. I still see water under the film in the center. It is drying but is taking a really long time. Once the water splotches dry up it will look fantastic!Update: 6 months later the blotches are STILL THERE. Now that its warm outside again, I will take the doors outside and remove the film and apply a different type of product.

Really doesn't cling like you're going to hope it does. The pattern is a little tighter than I wanted I was looking for that reed pattern

Looks nice enough but quickly comes off

Te despega muy facil

Un producto de muy buena calidad. Se pega con agua. Puede re usarse en otras ventanas tantas veces como sea necesario.

Brand new fast shipping

it's ok .. feels a little cheap