NINEO H11 LED Bulbs ,12000LM 60W H8 H9 Lights Halogen Replacement 6500K Cool White Extremely Bright All-in-One Conversion Kits | 360 Degree Adjustable Beam Plug & Play

This review is specifically for the 2018 F-150 XLT. I have read through all the reviews regarding the H11 bulb and the truck. There are not many but some are misleading. So I am going to try and make this as clear and dumbed down as possible for anyone else who wants these bulbs (yes buy them)-The H11 absolutely fits without any issue. The metal tabs that go into the housing to hold the bulb in place appear to be thicker and it takes a little more umph to twist the bulb but causes no damage. Line up the tabs with the correct size hole (2 smaller tabs and one large) and twist clockwise in or counter clockwise out. It should not take a lot of force as long as they are lined up-you will absolutely need a larger protection cap to keep the weather out. The reason is because the entire nineo kit will not go into the headlight housing (see pic). It sticks out. There has been complaints on this. Not sure what was expected. Just buy the cheap 83mm cap (see pic) for like 10 dollars for the set and your done. problem solved-easiest way to get to the bulb is through the wheel liner. there are youtube videos on this. One tip I will give is that it takes a bit of umph to get the pastic liner over the upper tabs that's along the fender flare section. you think that its going to break, but it will not. And it goes back on much easier than it came off-The 6500k, 12000 lumen set that I purchased is almost completely white with a VERY VERY FAINT hint of blue. The light looks high end and not cheap. It absolutely spanks the OEM, really bright. In fact some might think they are too bright. But not this guy.-Finally is the canbus deocoder. Do you need it?? Will your lights flicker? the answer is NO. Works just fine with no decoder. And yes I ordered one thinking I would need it because I watched a youtube video on a different brand that said it was a must and also read a NON-Verified NINEO purchase that was vague in the critical review. With the NINEO H11 low beam, there is no issue, and no error warnings.-Life of the bulbs...this I currently cannot comment on. When they go out I will update this. But they are 50 bucks for the set, supposedly last 30k hours. If they last even 2-3 years, I am fine with that as they are cheap in comparison to others, yet get the job done.-Additional Notes- 2-28-2020--- Had these for a few months and they still work fine. I also swapped out the high beams. I did notice after the first week that people were flashing their lights at me and when pulling up behind someone I could see my lights up in their back glass. So even though my lights were already adjusted, after adding the LED's I adjusted them down. Something about the lights change the pattern. After adjustment the lights looked more focused on the road, even far out, and no longer blinded people. Its very simple, just need a screwdriver (look up youtube videos)UPDATE-9/2/2020 Led lights are still running like a champ. Zero issues. Still hold the original 5 star ratingUpdate - 5/5/21 Still zero issues. The 5 Stars continues for both the high and low beamIf this has helped you out, please hit the "helpful" button. Its motivation for me to keep doing more writeups

I bought over 6 Amazon top rated LEDs for my nissan murano projector headlights. All were rated over 10,000 lumensLasfit LS, Hikari, Lightning Dark, Beamtech, JDM Astar & Nineo. Here is my experienceLasfit LS - Bright but scattered, do not get a feel of focus. Did not think its worth $120Hikari- Bright but not focused again - Cost $100 (90+tax)Beamtech - Not that bright. ReturnedLightning Dark - Bright without strong beam. Considered keep these till I got the Nineo.Nineo - Bright & good focus. I found this to be the best value for money at $50.Don't know the reliability but in terms of focus, intensity & cost Nineo wins over more expensive LEDs.Hopefully helps others looking for a good LED replacement.

These look AWESOME.. and very bright and crisp.. using in a 2015 Honda Accord. I was using super bright HID (real HID with ballasts) bulbs and these are MUCH better... very crisp bright and clean white light. Road signs are VERY visible and i've asked friends and family i've followed behind if they were distracted or impaired by my bulbs and they said no. So they're as bright as they need to be without being a problem to other drivers. Safe and bright is why we buy these, right? you can see the cutoff is below the driver position in the photo attached. It did take a minute to get used to the sound of the cooling fan on the back of the bulb. It was a new sound in my car and i was nervous till i realized what it was. Get these. Great price and great product. I'll update my review if they fail me at all, but for now they're exactly what i wanted.

Very pleased with lowbeam leds white with a tint of blue. Put in my new 2017 Tacoma and looks and brightens the roads great. Will be purchasing the fog lights also same size h11. Good price/quality plus 3 year warranty can't beat it. 👍🏼👍🏼👍🏼💡 also purchased fog lights 👍🏼 I tried to add a photo of the fog lights but won't let me . Looks great

I received the package and promptly installed these (H11 low beam) in my 2015 Nissan Murano. The following question immediately jumped right into my mind when I drove the car once the sun went down; Why aren't LED headlights standard?These installed without any problems, modifications, etc. Simply turn the existing bulb counter clockwise a quarter turn, pull out of the housing, push in the clip on the harness, and remove bulb from the harness. The only difference is that these stick out further out of the housing due to the fan and heat sink, and that you connect a longer cable (including a small 1x2 inch box) to the car wiring harness. This actually made it easier on my car to reconnect the headlight, as there is very little room to maneuver behind the headlight housing. I used two zipties to make sure that the control box wouldn't rattle. Entire installation took 10 minutes. Turning the car on, there were no error messages, which I believe means that there are no issues with the CANbus.Taking the car for a drive is (pardon the pun) night and day. Since the 2015+ Murano has projector low beams, the light is focused exactly where it needs to be. The light is bright white and, if I were to guess, twice as bright as the lights were when the car was new, and at least 4 times as bright as the 2+ year old halogen bulbs.Overall, I couldn't be happier. Five stars out of the box, I will update if any issues occur.

Bought these for our 2017 Mazda 3 GS Sport which was running with it's OE halogen headlights. It has H11 bulbs in the projector low beams and 9005 high beam/DRL bulbs which are reflector style. Given that our other vehicle has HID's, the Mazda headlights seemed dim, yellow and very inadequate on a dark rainy night. I did a lot of research and watched a lot of video's. I found Bulb Facts (bulbfacts.com) extremely helpful for their unbiased tests and ratings. Although the Nineo Gen II lights are not top rated for projector applications, they are near the top of the list, fit my car according to Amazon, and have good reviews.My shipment arrived 3 days early.! The bulbs come nicely boxed and look very well made. A very small allen key comes with the kit for adjusting the angle of bulb if needed. The instructions are pretty basic so I recommend watching some Youtube video's to prepare for the installation and get the procedure for your vehicle. I don't have access to a level driveway but I used the inside of my garage door to compare the halogen pattern to the LED's and make sure they weren't too high or scattered. As you can see from my photo's, I have a nice sharp cutoff good wide beam and much larger hotspot. You can see the small dark area at the bottom of the pattern but this isn't noticeable when driving. No problems with the installation or the fit. I felt the right side bulb twist a bit after it was secure so I removed it, realigned it, and tightened the set screw on the collar of the bulb. Nineo says to have the wider side of the bulb at 6 o'clock and the thinner side at 12. Mine came clocked that way but the loose set screw allowed one to turn out of that perfect alignment which really affects the light pattern. By the time I got out on the road to test them, it was snowing lightly. I took a pic on a street near my house where my old lights were very poor. The street is winding and there are deer in the woods on either side. The Nineo's are a huge improvement in terms of their nice white colour, good distance and wider beam pattern. No issue with any oncoming drivers flashing me. No flickering or dash warnings so far. The life remains to be seen. You can only hear the fans running if you turn on the lights with the car off so that is not a concern.For now I am not replacing the high beam bulbs since they are my DRL's and most of the LED kits wont' dim properly.

Your browser does not support HTML5 video.  Initially I got frustrated and thought about returning them b/c I didn't install properly. When I became able to install and while adjusting the beam focus (in projector housing), I felt a definite improvement over halogens' brightness.Thanks to 12k lumens and sharp cut-off which makes night driving safer.I'm impressed with the light output specially due to which signs are much more visible n getting easier to read.Pros:Extremely bright specially where no street lights are present.Straight n sharp cut-off means focused light down the road further and safer for cars coming from opposite direction.White light's reflection from road signs from far.Cons:(This is my biggest complaint)In installation guide, zip ties are recommended to use but not in the box.Summary:Final till I get better. Update left for longevity. I uploaded a video for reference.

This was supposed to fit my 2008 Chev Avalanche. It doesn't physically fit. The port to connect is correct, but the light is too long and hits the body of the vehicle. Upon return I'm loosing $10. I just simply would never buy this brand or from this seller ever again, what a waste.

I wanted 2 things from led headlights so i put them in the 2013 pete i drive haulin out of the woods.I wanted brightness and got exactly that.And totally eliminate the drive me off my rocker noise/static led's cause on my cb and got exactly that.I was impressed. Now i don't know what works to get rid of the same noise with 4, 4 inch led work lights on my mirror arms. Can you tell me what i need?

Ne vous fiez pas que l’article va fonctionner sur votre véhicule Même si ça dit que oui, vous le retourner et on vous charge 9.00$