Five OceansBoat Hatch, Marine Hatch - Boat Access Hatch, Round Inspection Deck Plate Hatch with Detachable Cover for Boat Yacht, UV Resistant ABS White Plastic, 4", 5", 6", 8" Multiple Sizes

This cover was a perfect fit for our 2001 Moomba boat. It was hard to find a 5" cover since most are 4, 6 or 8". The screw holes even lined up perfectly. The threads are deep, so it has a good grip. It comes with a plastic tie that connects to a center point of the underside of the cover. Unfortunately it doesn't include the screw, which is weird. It's not terribly necessary. I really doubt it will come unscrewed and fly off. I would definitely buy this brand again. It was much better than the factory one.

After receiving the deck plate, I used the ring to make a jig out of plywood that was laying around my shop. I used a pattern cutting bit on a router to cut the hole in the plastic where I needed access. I had to re-arrange some of the flotation foam, but the deck plate ring fit right in. I was then able to drill out the screw holes, install some clip nuts, then screw the plate ring right to the plastic. After replacing the flotation foam that I had to remove, the screw-in plate screwed right in, and I was done. I've bought and installed two of these, and if I ever need another one, I will be back to buy it here.

Use these on the plastic rectangular fresh water and waste tanks on my RV. I mounted / installed them on the upper top side to access the inside of the tanks for cleaning or inspection. Also, use these in the ceiling to access wires and things. Sturdy and easy installation! However, you will need to provide your own gasket and screws as these will depend on your installation application.

The plastic will give a little bit, so if this is installed on the floor of your boat it WILL bend in slightly if stepped on, so be careful not to put any pressure on it. Other than that the fit and look is nice.

Used on our new mast boot to seal leaks down below the photo has blue tape to hold while curing, have already had it applied under the clamp for a few days and no leaks after rain. Under the blue tape is just securing the boot. It will stick to fiberglass and gelcote, put on the outer ring of a deck cap, awesome stuff!

Not bad for the price. There seems to be less thread depth than the previous deck plates in my boat. Slightly disappointed with the strength of them if you step on them as they bow in.

I used this on the front wall of my DIY camper. It’s waterproof, easy to install, and easy to use.

exactly as described in the add & arrived in a timely fashion

A pretty decent hatch cover. It is made of harder plastic, so there is very little flex, and if the surface you are mounting it to is not 100% true it can be a little difficult to unscrew the hatch cover.I used these as a direct replacement for some old, weatherworn deck plates. They mounted easily in the existing cut out, screw holes matched up perfectly so no additional drilling was needed.All in all these are a great quality product. They seem nice and sturdy, but I am sure only time will tell how well they stand up to the weather here in Canada.

Comes with lid "keeper" and a gasket which was a nice surprise.Have yet to mount it and try it out!

I replaced the old weather beat hatch with the new one. fit perfect . happy with the puchase

Great replacement.

As described good quality marine part