Arkon VSM Adapter Kit for iPhone X 8 7 6S Plus iPhone 8 7 6S with Drill Base for Car Installation Retail Black

Use this on my motorcycle to hold my phone for use a gps. Works well however it needs rubber safety straps

I use this on a "ProClip Center mount for Ford Focus 11-14" and it works really well. Needed to drill 4 holes in my brodit clip but the finish is really good and it looks almost OEM.

I just purchased three of these for my three automobiles. I already owned the rather expensive ProClip brand combo solutions (both a custom vehicle mount and a custom phone holder), and I really like the ProClip solution, but (1) It's ridiculously expensive and (2) It only allows one phone to be used. I share cars with my wife and two newly driving sons, and the four of us each own a (very) different phone. So the rest of my family has to stare at (but not use) a custom phone mount for my Nexus 6 phone while their phones occupy a cupholder or slide around on the dashboard, etc.Not anymore! The good news is that my ProClip investment isn't a total waste because the I can still use the custom vehicle mounts with this Arkon phone holder. In fact, I'm using the identical screw holes and even the same screws (rather than the included bolts and nuts which can loosen). Arkon used to be my go-to phone mount, and I used to use their extra long gooseneck model that attached to the bolts on the seat base. Like ProClip, Arkon used to make phone model specific holders (I had one for my Palm Treo 755p phone), but thankfully this one is universal/generic, and can hold a wide size range of phones. Now whoever in my family is driving the cars can use the phone mount.It's very easy to use this phone holder, and for most phones you can put the phone in it with one hand/motion. With my huge Nexus 6 phone, the sliding clamp is pretty much at the limit, so in order to avoid stress on the ball joint, I usually put my phone in the holder using two hands. I've read several reviews that the ball joint on this holder eventually becomes loose and cannot be tightened down, so I'm being careful to not adjust/move the holder position much while the ball joint is tightened. The holder "prongs" are so small that it should be possible to hold any phone regardless of the position of the buttons on the sides of the phone. The "prongs" also are rubberized so they grip even a caseless phone very well.Time will tell how long it lasts (especially the ball joint), but so far I really like it. It's a much better (and way cheaper) solution than ProClip's, which makes you choose a specific phone model or at least a rather specific phone size that cannot vary much and isn't adjustable on the fly for using other phones. I still think the ProClip vehicle specific mounts are the best thing going, but this Arkon phone holder is the best phone holder going (at least for me) to install on the ProClip vehicle specific mounts.

Works well, however, I wasn't able to tighten the swivel tight enough, so I need to use 2 hands to insert the phone, otherwise it swivels.

Installed it in my jeep and tested it on the dirt road (lots of potholes) I take everyday to go to work and my Samsung S20 Ultra didnt move at all. Very sturdy, now time will tell if its worth my 5 stars 😉