Edge Supply Red Oak Wood Veneer Sheet Flat Cut, 24" x 48", Non Glued, 10 mil Paper Back,A Grade Veneer Face - Apply with Contact Adhesive Oak Veneer Sheet - Veneer Sheets for Restoration

These sheets are very well-made and adhere well to surfaces prepared properly.

I absolutely love this company! I do a lot of wood projects- and this company has saved my house! Their veneer is easy to work with, strong, and absolutely beautiful! I’ve used paper back and their psa veneer - and I can’t complain about ANYTHING! A few Pieces that arrived damage bc shipping- customer service swiftly replaced the entire pieces- and even over nighted the replacements- despite it not being their fault it was damaged. I won’t be switching “my wood provider” for a LONG time.

Overall a great product. I’ve used their veneer with adhesive and this one without. I thought that this had adhesive when I ordered it but it did not. Not a big deal I just used contact cement and it turned out perfectly. My only complaint is that so of the veneer was damaged when it arrived. Not a big deal since it was getting trimmed but for some this could be an issue.

I ordered this, expecting it to be a pain in the hiney to use, but I was wrong. I chose the width to match the table edge that I needed to repair, and the width was perfect. No sanding to fit! I tool my scrap piece from the damaged table edge and matched the stain color and glossiness at Home Depot. I came home and cut a piece to match the patch area (using a razor blade). This where I expected have problems: getting the glue to stick. I was wrong. Using the household iron on a cotton setting (dry), I quickly glued the 8 inch repair section in place. I thought the curve in the veneer would cause it to lift while the glue was still hot, but it didn't. After allowing it to cool, I lightly sanded it, then stained it to match. It took a couple passes with the stain to get it dark enough, but the end result was a pretty damned good match. I masked it off and sprayed a Varithane semi-gloss over th top, and it was done. Now, does anyone want to buy a table?

Worked for my project, good for the product I was working on.

This product is delicate and did not react uniform to my stain. This is natural wood product and I had some problems using contact cement to hold in place. Take your time when using this product and it should work out.

This is high quality. I like the extra width as I used it on 3/4" oak plywood. It matched the plywood perfectly. I used a professional cutter to trim it up and then light sanding did the trick. I used an old clothes iron set on one notch from the hottest possible. I went over it and then used a dowel to rub it down flat and then slightly over the edges. I went over each piece a total of three times. I even had to go over a rounded portion on the end of a Wall-Bed and it held very well. I highly recommend this banding.

great grain structure flat easy to cut I highly recommend this product for veneer applications