Universal 2pc 5050 Led Motorcycle Bike Amber LED Turn Signal Indicator Blinker with Total 12 Led

I thought this was a hard mount but it is only the flexible lights needs to be in some kind of housing

The media could not be loaded.  Installed 2 sets of these on my 2018 Ducati Scrambler Dessert Sled to replace the bulky factory turn signals. The installation was much easier than I'd thought it would be. I am usually no good with vehicle electrics. The included wires are very long, you could probably make these reach anywhere on your bike. The 3-M adhesive tape is strong, but do yourself a favor and clean the area you're attaching to with a bit of rubbing alcohol first. I was apprehensive about cutting back the factory wires, but after an hour all four were blinking brightly and at a normal speed the first try without adding a new flasher module or resistor. Check with your dealer but for the 2018 Ducati the CAN recognized the LED and automatically adjusted, zero changes needed on my part, install was truly plug and play. I chose to solder, electrical tape, then heat shrink the connections, but as long as you don't mess the wiring colors up and it's reasonably weatherproofed any connection should do. I love the look, they're plenty bright and almost vanish when not lit up. Very positive experience.

I get up periodically during the night and this lights up the room by motion sensors. Great product.

Goog

relatively easy to instal, I spliced these into my side flat-mounted blinkers on my R3 and put them on the front of the bike so I have both a side and front blinker visible to drivers. Very bright and uses low wattage. They come with no instructions, but there are videos on youtube on how to install these and similar lights on youtube. I have had them on the bike less than a week so I can't speak for longevity, but if they last, they are worth every penny,

The media could not be loaded.  Ordered Rage360 signals for my forks and needed comparable LED signals for the rear of my bike. Great quality, especially considering these were 1/10 the price of the rage signals. Put them on my swing arm which probably isn’t “legal”, but it was the only real solid place I could put them. Cleaned the swing arm well with alcohol before I attached them and they have been sticking well ever since. Have been attached for 2+ months through water and mud.

The glue still lasts after two years, they are mounted as turn signals on my navigator 2000

Once I got everything wired and working, I can say these lights are bright and work great! The adhesive sticks on really well and stays on. I would highly recommend this product to anyone looking for a bright blinker on their bikes!