UTG Super Slim 13 Slots Picatinny Riser Mount

Surprisingly well built and solid. Nice riser.

This riser raised my scope to where the sight picture FINALLY was useable. Nice finish, fit perfectly and was needed. Couldn't find 1" rings high enough. Very happy with the purchase and it was affordable.

I wanted to replace the open sights on my Diamondback DB15 AR. This rail was the trick to getting the red dot scope elevated enough to set the dot squarely in-between the front sight wings. I used an A2 pin removal tool to take out the front post, and the dot fell almost immediately on center, exactly replacing the top of the pin. Now just put the dot on the target for nice, tight groups. This 0.83" riser was exactly the correct one. I also bought the 0.75" riser and it was a tad low for my application. What I found is that it fits nicely onto the rail, and when snugged down, it remains solid, and has remained so for the last 100 or so shots. I may decide to add a big of loctite now that I have decided to make it a permanent optics solution, but it's probably not necessary. I will wait until the next service.

The product is exactly as described, running the whole length of the top rail of an upper. I am using it to raise a red-dot and magnifier.The product itself looks great, so you won't sacrifice "tacticool" by adding the riser. It installed very easy, using three torx screws to tighten. Torx screw wrench and extra screw are included. It is extremely light-weight, yet does not seem cheap.I haven't fired the rifle with it installed, so I can't speak to how durable it will be in the long run.

The mount is well machined with nice bevels to remove sharp edges, and the recoil lugs set it aside from a lot of other risers out there from more expensive brands. BUT, since the clamping bar is across the entire length of the unit and it uses relatively wide, countersunk screws, the clamping bar raises high enough that for many common one piece scope mounts or QD magnifier mounts, the mount and clamping bar collide and it won't fit.I'd suggest downsizing to a T10 instead of a T15 sized head, and possibly using a counterbore instead of countersink screws. It's a shame cause I really want to like this mount but can't for my desired dot/magnifier setup

Do your research. This a great fit and awesome addition. Be patient and think it through before trying to install. Great product.

My boyfriend told me to order this for him. He said it was exactly what he needed for his weapon. He likes it so we’re good.

This riser was perfect for what I needed. I bought the 0.5 inch. There is no thread locker on the screws, but that's okay because I added my own. Good fit and quality.

Hat gut gepasst

Tutto perfetto, prezzo buono,Bel materiale!!!

Echt zu empfehlen, top Produkt !

I'm extremely impressed with the quality of this product, easy to attach and lightweight, fitted perfectly on my picatinny rail and rock solid when tightened on. I used it in conjunction with 2-piece 1-inch high mounts it is perfect for airsoft.Also only took 2 weeks to arrive even though six weeks was stated.Admittedly not the cheapest way of raising your scope but worth every penny, remember you get what you pay for!! would definitely buy again and recommend.

I thought the price is a bit high for a riser mount to begin with but when I have the mount in front of me, I think it's well worth the price, both the finish and the precision is exceptionally good. It even comes with an extra screw. Great riser mount overall and I am thinking of getting another one as a spare.