CK FORMULA48 Inch LED Tailgate Light Bar for Trucks Triple Row - Tailgate Light Strip, Amber Sequential Turn Signal, Double Flash, Red Brake, Running, White Reverse Light, Truck Accessories, 1 Pack

Worked to perfection.

I was able to use the adhesive to install to my SUV's rear bumper without any additional fasteners for the adhesive it great. It has gone through the was & holds up. I did install a water-proof fuse holder, as I live in Wisconsin & salt from the roads would corrode it otherwise. It is super bright & the multi functions is great to get drivers attention.

The lights were great for the first 2 mos and now they are almost all out. Parts of the function 90% are gone and some functions are ok. I really am disappointed in this product. Don't recommend, especially with the work it takes to install and to have them not work so soon.

For my 2015 Toyota Tacoma I plugged in to the existing plug for towing. That meant everything worked great, except for the backup white lights. For those you need to run the loose wire that's not in the plug, to the hot side of a backup light. So you'll have to do some soldering/crimping and wire protection for the wire run - I ran it inside the driver's side taillight and exposed some bare wire and crimped it. For wire protection I just used extra-strength duct tape to tape it flat against the rear body below the bed lol...but it was a short 6" run and it should be OK.The brightness is outstanding. Now I can actually see well when backing up at night! All the other functions are bright, too. I would buy this again if I needed to.

Very bright ! Easy to install

Easy to install and all the lights work good. Only thing not working is left turn signal. Right signal works perfectly fine. Left signal will not work. Also only right side works when caution lights are on. Shame I was so close to getting one that finally worked right and everything works just fine except for the left turn signal

Super bright lights love that the turn signal stages out from the center really thick coating only two thing I have u need to buy wire lum for the wires and you to buy some loctite spay on adhesive for the very end of the like the very ends on both sides do not stick and it try’s to pile up from the ends get the adhesive spay it on the end and hold for about 10 mins and no more pealing up

And my prevent you from getting rearended

All good

Installed it with no issues but after a few weeks the led lights in it have burnt out very disappointed with the quality of the light