Honoson 12 Pcs 6 Pin 12 mm LED Strip Connectors L Shape Solderless Unwired LED Light Connectors for Light Strip and Extension Cord

These connectors are garbage! They all need to be endlessly adjusted to make them work. Just when you get a solid connection and place it, they go out. Don't waste your money. Find a high quality connector. These are complete JUNK!

Of the five connectors, I was only able to get one pin-to-pin connector working. The other four connectors had very poor soldering: one had pins shorted together, two had pins disconnected, one was barely holding together and completely pulled off the solder as soon as I handled it. The connectors for sliding onto cut strips were similarly problematic, they don't make good contact. Expect to do soldering if you want to make these actually work.

The pieces slip out from the connectors so easily. Garbage product and you will need to solder to get them to work properly

These connectors worked very well on my RGBWW LED strips. easy to close, and had no connection issue at all.

Have used this kit before to install light in other TV. Used this (my third set) and they were defective. Previous 2 set bought worked [perfectly. . The angle strips were loose on the socket. Giving a poor connection.. I do not know if I got a "bad batch" (no Star Wars pun intended) on this occasion, but connection was poor and looks like they used less plastic and the pressure area is smaller. Very disappointed this time with sell. Threw them away and just bended the strip on the corners, not happy and will buy with caution.

Piece of garbage. Pins easily breaks, burnt, not safe either. I tried to use this with 4 Govee led strip, 8 cuts, I could make only one works, but it turns on and off, changes color too. Very cheap quality

They did not make contact with the led strip. Tried many different connectors. Some connections were getting very hot. Would have possibly causes a fire. Once installed the lights were flickering alot. I sent these back and bought the kind that pierce the led strip. They worked flawlessly.

Long story short, it is amazingly difficult to maintain a secure connection across all 6 pins no matter what type of piece you use from the kit. You absolutely need an exacto knife/razor blade handy to make clean cuts on your light strip, make sure the cut is STRAIGHT at the point of connection, and remove any covering the strip had back about 1/2" from the cut to allow enough clearance for the strip to fit all the way under the connectors on the kit pieces. Good luck.

Tbe quality isn't good

switchbotテープライト３で利用出来ました

As advertised

Broke the pins on my led strip. Used the double sided pin on the other side. Fixed it easy.

Item does not make a full and proper connection causing the second strip of lights to not work