APS iBoard (Black Powder Coated 4 inches) Running Boards Nerf Bars Side Steps Step Rails Compatible with Ford F250 F350 Super Duty 1999-2016 Super Cab

Four stars because the "T" bolts that hold the boards to the brackets are cheesy. I broke one with minimal torque (I'm a mechanic and it should not have broken that easily). That said, the brackets go on easily and THAT hardware is sturdy enough for the job. Took about 1 1/2 hours with plenty of breaks due to it being hot outside, no drilling.These do NOT bolt to the frame but they ARE sturdy and attach to the lip at the bottom of the cab and higher up on the factory installation points. Look good, SOLID, 250 pounds and bouncing a bit causes only a barely noticeable "give". Normal use they will do a fine job.

Arrived as stated and I installed them immediately, instructions were straight forward and easy. Only had one tiny issue. They sent 8 clip nuts and 7 of them were perfect. There was one that was the wrong size. It was smaller and could not use it. I only received 15 “T” bolts so I was shy one. Other than that the fit was perfect for my 2011 Ford F-250 supercab. And work perfect. Will have to look for the pieces that were either not included or wrong size and correct what I need. I would have given 5 stars if all was included correctly. But I am happy with them.

I like the product. I thought, they’d be maybe couple inch’s lower and wish they were an inch wider. I really have nothing to complain about with them though. I plow snow with this truck so it my be good thing to have them tight to truck. Less chance of being damage on frozen snow bank.

These absolutely DO NOT fit a crew cab F250. For the people that say it does they must like driving around looking stupid. If you place the boards near the factory position (say just up to the front door and fender seam) the running board will END HALFWAY DOWN THE BACK DOOR. If you set it evenly the boards will start 8-10" back from the front door/fender seem and end a solid 9 inches short of the end of the back door. Well made but they DO NOT FIT A CREW CAB.

Pretty nice running boards and really nice for the price. It comes with brackets so that is a real plus. The instructions weren't all that great but this is not rocket science. To simplify installation the idea would be to put the brackets on loosely, slide the 10mm bolts onto the running board, place them through the holes on the brackets and tighten them, then slide the mounting brackets into place and tighten them. BIG TIP... do not overtighten the 10mm bolts holding the running board to the bracket. You will break them.The 10mm bolts are the only real problem I have with the running boards. They are cheap.I would recommend these boards because they are pretty nice and they are a great price.

Easy to install,well made and look great. Took me about an hour. These are the 5 inch regular(not w2w)

I had both sides done in an hour! Fairly strong though it doesn’t bolt to the frame. However, my wife and I aren’t heavy so it should work out great.

Nice and sturdy and easy to put on. My 15 year old grandson put them on

I had to reinforce with metal square pieces for them to firm up and not bend. Om both sides of the installation.

like the straight design and the construction

tres bon service et bon produit