Full Assembled Ender 3 Hotend Upgraded Kit with Nozzles 3D Printer Parts Accessories Replacement for Ender 3s/ Ender 3 Pro 3D Printer

I was having issues with a clogged extruder. Decided it was best to replace all of the hotend parts. This was the perfect solution. It was easy to open the bottom end of the machine to access the ports for each plug. Advice: take a picture before removing the old piece. This made it plug and play without any fuss. It included all of the parts including zip ties which are so important to keep the wires neatly together. Now my prints are amazing with no clogging.

Works great, watch your wiring. The quality is first rate and is just want I needed for my ender 3, a great price as well. I suggest that you take photos of your original wiring with your cell phone before disassembly as there is what appears to be an extra wire on the new Hotend that will be confusing as to where things go on the new one. Take photos of the wiring on the old Hotend and where they connect on the circuit board. I followed what was an extra wire on the new Hotend and compared it to my old one and plugged it in the location I thought it belonged in. If you pay attention and look at your photos as I suggest its obvious to figure it out. Overall though a great replacement.

Super easy install. Just took off a few screws, and plugged in everything on the new extruder right where the only ones went. Intuitive, and immediately printed great on the first try. For the cost, it works great, and is cheaper than other assemblies. Looks and holds up just like the original.

This is a good replacement for your stock Ender hotend if your NOT looking to upgrade but just to get your printer running. It's easy to install as it is a direct replacement and no cable splicing or anything crazy is necessary. It provides the same print quality as the stock hot end and is a good bit cheaper than most alternatives. Only downfall was out of the box there was some heat creep causing my prints to fail after a certain point. (Loosening the two screws on the bottom of the hot end by the nozzle and re rightining them *snug not over torqued* seemed to resolve the heat creep issue.)

I had not used my non-pro Ender 3 in close to a year, but I decided to start up again. It was printing like garbage, so I opted to cleanup the nozzle and whatnot. When replacing the nozzle I accidentally stripped the threads on the aluminum block on the hotend, so I had to replace it. Anyway, I installed the factory hotend with this one, and as soon as it was on, the machine started printing perfectly, I didn't even have to adjust my Z-offset for the BL Touch. I've only had it one day, but I cannot recommend this replacement enough.

Came pretty quick. No instructions at all. The one that came has totally different color wires and nothing is labeled so trying to figure where everything goes is frustrating.

Not quite plug and play but still simple enough to replace. No issues so far.

Way better than anticipated for the price point.

para los que tienen impresora ender 3 pro, el articulo viene con cables amarillos y azules para los ventiladores, el amarillo es positivo, el azul es negativo, deben cortar el cople de los cables que van a la tablilla, los que tienen una etiqueta que dice "axial fan" o "axial fa". Debes conectarlos de la siguiente forma: en donde iba el rojo va el amarillo, y donde iba el negro va el azul. El ventilador turbo no hay problema, solo se conecta directo a donde iba el anterior. los cables rojos del inyector se conectan donde iban los anteriores, son los dos cables rojos de mayor calibre, no importa que orden se conecten esos. Los cables blancos con cople van donde iban los cables negros que tienen cople