Front/Rear Drive Shaft 115-139mm for RC Slash 4X4， Slash, Stampede 4X4 VXL VXL Stampede

Quality is so-so I would highly recommend putting a drop of thread loc on all set screws. The set screws that hold the pins in at the swivel come only finger tight. I also used a couple drops of super glue to keep the pin spring retainers from falling off or a drop of shoe goo would work also..

Disappointed to say the least. These seem to be of average quality, however they do not come with the proper hardware. Can not install as the location of the threaded pin used to secure the axel to the diff is WAY over sized to reuse original pin and these don’t come with one that fits axel. The picture shows one of the largest diameter chassis screws threaded into the axel next to original axel pin....since I can not install I can’t say anything about durability.... debating if it is worth the time to find or make a method of attaching or just return? After drilling and taping the non threaded side for a second set screw to try to evenly clamp from two sides. I did a quick test run about 10 minutes and can say a thing about durability now... after applying thread lock to set screws and some grease to the joints they are showing lots of slop and binding... definitely will not hold up to any kind of speed or power... again totally disappointed not worth time or money!

So i quickly found out you need bigger set screws to connect it to the transfer cases. I did read the comments (unfortunately after I bought them). So i did go ahead and add some blue threadlock to all the set screws before i put them in the truck. Another issue is they use bigger wheel nuts. The factory ones do not fit the new output shafts. So it was a pain in the ass to tighten the new bigger nuts inside my hoss vxl wheels. They are heavier so im not 100% sure yet if they are causing my truck to slow down from having to turn the heavier axles. I will update in a few days after i get some more run time with them.

Used on a traxxas slash 4x4 ,had to make major adjustments just to use the rear shafts .

This was to replace drive axles on a Stampede 4x4 VXL. Problem 1, no Allen pins to attach at the transmission.Try to find them! Oversized. #2, at the other end I had to enlarge the tire " rim hole " .as the threaded end is Oversized.

These use special hardware that is not included and I can't get a reply from seller on what screw pins are missing or size needed so I wasted money on these paper weights that are useless without parts seller will not reply

The axles don't come with the pin screw to conect it to the diff and now I can't drive my car until I find a way to get screws because the stock ones don't fit it. Very disappointing when I planed to drive today and now I can't and don't have the parts on hand to use it 😡

JUNK will not stay together always falls apart DO NOT BUY