Dehco Heng's 16-46128-4 Roof Coating Rubber Roof - 1 Gallon

Only needed half of the gallon to cover my 9 foot camper rubber roof. This is the third application on this 32 year old slide-in camper, and I've never had leaks. It's easy to apply, using a paint roller and long handle. Be sure to follow the surface preparation directions and weather conditions needed during it's application.

Just wanted to write a note to affirm what every one else has said. I have a 31 foot class c that is 11 years old and nothing has been done to the roof. no leaks yet but did not want to wait for one. I cleaned the roof with a strong cleaner(Zep) and a shrub brush, then put first coat on with a 4" brush because was not sure how far 2 gallons would go, put second coat on with a roller, I still have a half gallon left so will put on a third coat. For the price I don't think you could find a better product.

We purchased a can of rubber roof coating for our RV camper. The can was quite dented, but the product inside was ok. It's what is inside the can that matters.

I ordered this in the spring of 2017 but never used it until Oct. 2018. My trailer is stored indoors so I wasn't worried about getting it done. This trailer had spent its life in the hot Arizona sun and was experiencing small hairline cracks. After reading the coverage which said 200 sq. I measured my trailer. My roof is 28' x 8' feet, which is 224 sq ft. The instructions said that it can be watered down with up to 1/2 pint of water. I was concerned with coverage so I added less then a cup of water since I have an air conditioner, 2 roof vents and a bathroom skylight to lessen the sq. ft. to cover. I used a paint rolled and brush to get in the hard areas. After I finished coverage and went around the fold over edges in the sides with a brush I still had almost 1/2 gallon left. This product paints on very easy just like paint. I didn't want to have any left over so I added a small amount of water two days later and painted a second coat over the top. I did not use the brush to get around the air conditioner, vents and over hang rubber but after this coat I still have enough left to do the brush work. I will do that to use up the rest.

Did not receive the picture product and was severely dented

I bought just 1 gallon. I've just put on the 2nd coat. 1st coat on my 33 foot Allegro went on fine with about 1/3 gal left. So I diluted the remaining product with water at the maximum dilution allowed - this amounted to 1/3 pint of water. It went on fine with zero left. So far so good!! An amazing product!!

Easy to apply with a roller. Stands up to New Mexico sunshine and winter snow.

The product is great !!! But it was shipped and was damaged on arrival !!! Leaked everywhere