EXTRACTME Upgraded 12 Way Fuse Block Box with Thumbscrew and LED Indicator, 12 Circuit Blade Fuse Box Holder W/Negative Bus Damp-Proof Cover Label Sticker for 12V/24V Auto Car RV Marine Boat and Yacht

this product is supposed to be capable of handling two rails of 100amps each, with each of the individual circuits being rated for a max of 30amps. ( though they show 40a fuses/ circuits) .BUT the internal wiring is ~20ga & will not support 30a. the buss bars and fuse holders are decent grade and gauge but the wiring is waaaaay too small for the load.be prepared to replace all the internal bridge wires.to me, this is a hazard and I expect the stock wires to melt and burn at load.refer to photos. that ONE red wire is the main (200A!) feed and there are black jumper wires of the same kind for each fuse location.each of the 13 wires should be upgraded to 12ga or better, for this to be safe.

I love this fuse box! When a fuse is blown a red light next to that fuse comes on so you can see right away which is the blown fuse, also the thumbscrew holds the cover on without worries of falling off. It’s well made & I’m totally satisfied! Would recommend this 100%

Just received the fuse box. Have not installed it yet but the quality seems very good. Won't get chance to install for another couple of months (gathering all components to build the electronics cabinet for van conversion).

Using this in my shuttle bus to RV 12v electrical system. My initial test with it seems to work well. I like the knob on the front so I can easily take it off and know for sure that the cover will stay on.

Awesome little fuse block. Be carful buying other similar brands, this is the one you want. The negative posts come off the sides same as the positive posts. Other brands have the negative terminals that come off the top.Good construction. It's defiantly not waterproof though. I would consider it more water resistant up to a point.

Easy to install. Good indicator lights. Tight connect.

Love the lights on that illuminate when a fuse is blown. Rewired my 82 center console and used marine connectors and rings on all the terminals. No issues so far

The terminal screws for the positive load lines are a little too close together for some ring terminals. I had to trim the edges of the ring terminals to get them to fit.

Solder joint inside broke within a week and I had to re-solderit. Then it broke at another spot.Now it resides in my garbage pale where it belongs. Buy the Blue Sea one, very happy with that one now.

Small screw use a magnetic screwdriver so you don't lose the screws.

Simple easy to use design but was rattling out of the box. 3 fuse positions have issues with contact power with no fuse installed. Bad for draining batteries

Used in my boat to organize the electronic wiring ! Easy installation! Ready to go!

Installé dans mon VR