ACCRETIONTR412 Rubber Snap-in Tire Valve Stem for Tubeless 0.453 Inch 11.5mm Rim Holes on Standard Vehicle Tires (Set of 4)

These are quality valve stem and should last a long time

Install was easy.

They seem to work just fine.

Have a wheelbarrow with 15" Diameter tire . It was flat so i used my compressor unfortunately the stem popped off due to the rubber corrosion. I have never replaced a stem before in a tubeless tire but i decided to give it a go as replacing the same type of tire would not be worth it considering how often it is used. Popped out old stem, measured hole size and ordered this item as it indicated it was the size i needed. Had to pry the tire back near the hole which was a bit difficult as it was a stiff old rubber tire but after a few choice words and a couple of clamps it was finally far enough back to insert new stem from inside. used pliers to pull and twist and trying not to squeeze pliers too hard to avoid damaging inner workings of stem and VOILA ! ! done. Maneuvered the edge of tire as close to edge of rim as possible, fill with air and pat myself on the back for a job well done.

great

These little valve stems work in small tires like on dollies and we’re just as good as anything you would buy in a Brick and mortar store if you could find them there.

Had to order 0.625 for what I needed them for which is to air out my 5 gallon gas tanks from the back. Did this about 15 years ago and they finally rotted out.

I've been changing my own tires for years didn't realize there were two different sizes make sure you get the right size diameter