Replacement Engine Pulley for Snapper 21707, 2-1707, 7021707and 7021707YP

Exact fit. Mower works like new now. Belt groove in old pulley was worn, causing the belt not to grab.

worked great for my 1990 commercial toro push mower. Bought a new motor and the old one was different and wouldn't fit the shaft had to go to a smaller size. I've been using this for a bit and haven't had any problems

New engine on a Snapper self-propelled needed a 7/8" drive shaft pulley. This one fit the bill but turned out to be slightly smaller OD than the original 1" bore pulley. Was concerned the stretch belt wouldn't fit tight enough but it worked out fine. The speed is actually faster now than it was w/the old engine and pulley. Did have to file off a nick on the bore edge, but otherwise it fit as expected.

Used to fix our lawn mower. This part was as-advertised and fit perfectly.

I removed my tired B&S Quantum engine with 25mm (1 inch) shaft and replaced it with a fresh Tecumseh VLV55 Vector carb engine that has a 7/8 drive shaft.

It fit well but V-Belt groove diameter is smaller so I had to get a new drive belt. It wasn't a problem

Fit exactly on my 25 year old Snapper 21" with 4hp Briggs & Stratton. Mower that I used to have to push up slight inclines now pulls like a billy goat out to have some fun. Set screw is included. No reason to pay more.

worked great,good rice.