SC-5 Tungsten Carbide Burr Rotary File Cylindrical Shape with Radius End Double Cut with 1/4''Shank for Die Grinder Drill Bit

I had several doors where where the latch and strike plate were slightly off, so the latch never set properly into the plate. After watching several videos, I purchased this rotary and it worked out perfectly. Just used it to grind the side where the latch was not catching and now all my doors shut with no effort. Good quality and good value for the money spent.

I liked this product a lot. My door key-holes were a bit tight for the new doorknobs that I installed, so I used this to grind the openings a bit. It was super easy and kind of fun. Using the drill too fast can make you lose control a bit, and not target a long space quite as nicely, but with any tools, it's just a matter of learning how to use it properly. And it seems pretty sturdy, I'm not concerned about it wearing away anytime soon.

everything fine

Works as designed for a fraction of the cost of a known brand. Can’t say I use it all the time but has worked for me every time I’ve needed it.

Appears to be carbide as described. Used to bore a channel through fire brick to run heating element for a heat-treat oven. The nature of that material would very quickly destroy anything other than carbide; the bit did its job efficiently.

Pretty good quality for the money.

Unlike the burrs available at the discount box stores, this burr seems a lot tougher. I haven't used it on metal, but I suspect it will last a while if not abused.

Worked better than I thought it would. Used it to clean up welds in the corner of angle iron where I could not fit in the grinder.

Works great for a diy'er like me

Great for hole enlargement

Aucun problème avec l autils+++++++

It took awhile to clear the medal however it did the job. Sturdy and robust.

Great value.