XSPC EX480 Radiator, 120mm x 4, Quad Fan, Black

For the price, this is a very good radiator. The width of the radiator is a little smaller than radiator products made by EKWB, which made for an easy installation in the top of the Phanteks Primo case I was using. It does only have two ports, facing down at one end, but I can't imagine someone being able to use end-facing ports on such a long radiator (that would truly require a monster case!). The radiator is thin enough to allow push/pull in many cases, although there seems to be much disagreement in the community whether push/pull gets you significantly much more cooling as long as you are using good fans in either push or pull. I did not see any debris when I washed out the unit thoroughly before use. It has a very solid feel yet it is light compared to other vendor products because the cowling is modest. The bolt holes all threaded the screws well. I would definitely use XSPC radiators again.

This radiator is pretty badass. I have two 120mm fans and a 200mm pulling out, and 4 120mm fans pushing through the radiator. All in all it's definitely doing the job of dissipating the heat from the water nicely enough to get a decent overclock, but you can only put it in one way. I tried putting the barbs toward the back of my case, but I had to turn it and make the hoses go down through a couple of my drive bays, because not all of the screw holes didn't line up the opposite direction. Which really is fine since I have an AZZA full tower, so I have plenty of spacing otherwise. Just be aware that this does not come with fittings. I already purchased some through titan rig beforehand for aesthetics and I'm glad I did.

I love the fact that this comes with the screws needed. I also love the fact that in my current push/pull configuration this radiator is keeping myprocessor and video card cool even under 4k gaming. I have run this system through the ri ger and it just keeps stable and temps under load on my 125 watt processor and my 980ti kingpin never go over 40C.

would recommend 100%. Had these for nearly 2 years and they are still holding up well. I always trust XSPC products

Amazing rad. Dispels heat well and also looks pretty nice. You will need to wash it out when you get it but that's to be expected with cheaper radiators. The fin density is really nice too, honestly this rad is enough to run a cpu, gpu, and if you're really outrageous then ram too. I comes with all the the screws you need but it does not come with fittings or caps. The holes are plugged with simple plastic inserts.

Works like a champ! I have a Phanteks Enthoo Primo and was using a thick Koolance radiator on the top push/pull.I get the same, if not better, temps with this radiator mounted on the bottom.The old radiator did not fit at the bottom of the Phanteks case, it was too wide, this one fits perfectly.

Just as described

I like this radiator, but I wish it had more than two G1/4" ports. With my next build I will go with the Alphacool NexXxos XT45 radiator.

3900x and 4 slow fans.Doesn't ramp up.Stays about 50cBrilliant radiator.

Der Rest meiner Wasserkühlung ist von einem namhaften Markenhersteller, aber beim Kühlkörper griff nach einem billigerem Produkt und bin nicht eintäuscht. passt spitze, kühlt perfekt, bis jetzt nichts negatives zu vermerken.

Super preis top ware